Installing And Removing A Fan Module; Installing A Fan Module - Cisco UCS 5108 Installation Manual
Chassis
Hide thumbs
Also See for UCS 5108:
- Spec sheet (50 pages) ,
- Manual (8 pages) ,
- Installation manual (95 pages)
Table of Contents
Advertisement
Installing and Removing a Fan Module
Installing and Removing a Fan Module
You can hot swap a fan module (N20-FAN5) without causing an electrical hazard or damage to the system.
However, you can only remove one fan module while the system is operating. Removing more than one fan
module could cause overheating.
Note
When a fan is removed, louvers inside the chassis prevent recirculation of air into the system or loss of
cooling. However, you should not leave the chassis for extended periods of time without all fan modules
in place.
Installing a Fan Module
Procedure
Step 1
Hold the fan module with the spring latch at the top of the module.
Step 2
Push the fan module into the chassis until it seats properly and the spring latch snaps into place.
Step 3
Listen for the fans if the chassis is powered on. You should immediately hear it operating. If you do not hear
it, ensure that the fan module is inserted completely in the chassis and the faceplate is flush with the outside
surface of the chassis.
Step 4
Verify that the LED behavior is as expected. See
page
Figure 49: Positioning a Fan Module (N20-FAN5) in the Cisco UCS Server Chassis
Cisco UCS 5108 Server Chassis Installation Guide
82
36.
Installing and Removing Components
LED Locations, on page 35
and
Interpreting LEDs, on
- Quick Links:
- Cisco Ucs 5108 Server Chassis
- Leds
Hide quick links:
Advertisement
Table of Contents
