Removing Dynamic Address Entries - Cisco Catalyst 4500 Series Software Configuration Manual
Cisco ios xe release 3.9.xe and cisco ios release 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages) ,
- Command reference manual (1230 pages)
Table of Contents
Advertisement
Chapter 4
Administering the Switch
Command
Step 4
show mac address-table aging-time
Step 5
copy running-config startup-config
Removing Dynamic Address Entries
To remove all dynamic entries, use the clear mac address-table dynamic command in EXEC mode.
You can also remove a specific MAC address (clear mac address-table dynamic address mac-address),
remove all addresses on the specified physical port or port channel
(clear mac address-table dynamic interface interface-id), or remove all addresses on a specified
VLAN (clear mac address-table dynamic vlan vlan-id).
To verify that dynamic entries have been removed, use the show mac address-table dynamic privileged
EXEC command.
Configuring MAC Change Notification Traps
MAC change notification allows you to track users on a network by storing the MAC change activity on
the switch. Whenever the switch learns or removes a MAC address, an SNMP notification can be
generated and sent to the network management system. If you have many users entering and exiting the
network, you can set a trap interval time to bundle the notification traps and reduce network traffic. The
MAC notification history table stores the MAC address activity for each hardware port for which the trap
is enabled. MAC address notifications are generated for dynamic and static MAC addresses; events are
not generated for self addresses or multicast addresses.
To send MAC change notification traps to an NMS host, perform this task:
Command
Step 1
configure terminal
Step 2
snmp-server host host-addr
{
}} [
1|2c|3
auth
[udp-port port] [notification-type]
[
traps | informs
|
|
]
noauth
priv
community-string
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Purpose
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Purpose
Enters global configuration mode.
] {
Specifies the recipient of the trap message.
version
For host-addr, specify the name or address of the
•
NMS.
Specify traps (the default) to send SNMP traps
•
to the host. Specify informs to send SNMP
informs to the host.
•
Specify the SNMP version to support. Version 1,
the default, is not available with informs.
For community-string, specify the string to send
•
with the notification operation. Though you can
set this string by using the snmp-server host
command, we recommend that you define this
string by using the snmp-server community
command before using the snmp-server host
command.
For notification-type, use the mac-notification
•
keyword.
Managing the MAC Address Table
4-31
Advertisement
Chapters
Table of Contents
Troubleshooting
