Cisco Catalyst 4500 Series Software Configuration Manual page 945
Cisco ios xe release 3.9.xe and cisco ios release 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages) ,
- Command reference manual (1230 pages)
Table of Contents
Advertisement
Chapter 35
Configuring Layer 3 Interfaces
Figure 35-6
Corporate
network
Figure 35-6
network 10.3.1.0/24 and network 10.2.1.0/24.
If the 10.2.1.0/24 link between distribution router 1 and distribution router 2 has failed, the lowest cost
path to network 10.3.1.0/24 from distribution router 2 is using the remote router (see
route is not desirable because the traffic that was previously traveling across the corporate network
10.2.1.0/24 is now sent across a much lower bandwidth connection. The over utilization of the lower
bandwidth WAN connection can cause a number of problems that might affect the entire corporate
network. The use of the lower bandwidth route that passes using the remote router might cause WAN
EIGRP distribution routers to be dropped. Serial lines on distribution and remote routers could also be
dropped, and EIGRP SIA errors on the distribution and core routers could occur.
Figure 35-7
Corporate
network
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Dual-Homed Remote Topology With Distribution Router 1 Connected to Two
Networks
10.3.1.0/24
Distribution
router 1
(hub)
Distribution
router 2
(hub)
shows a simple dual-homed remote router where distribution router 1 is connected to both
Dual-Homed Remote Topology with a Failed Route to a Distribution Router
10.3.1.0/24
X
Distribution
router 1
(hub)
Distribution
router 2
(hub)
Configuring EIGRP Stub Routing
Remote
router
(spoke)
Remote
router
(spoke)
Figure
35-7). This
35-17
Advertisement
Chapters
Table of Contents
Troubleshooting
