Marking Statistics - Cisco Catalyst 4500 Series Software Configuration Manual
Cisco ios xe release 3.9.xe and cisco ios release 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages) ,
- Command reference manual (1230 pages)
Table of Contents
Advertisement
Configuring VSS QoS
Command
Step 9
Switch# show policy-map name
Step 10
Switch# show table-map name
The following example shows how to enable marking action using table-map.
Switch(config)# table-map dscp2Cos
Switch(config-tablemap)# map from 8 to 1
Switch(config-tablemap)# exit
Switch(config)# policy-map p1
Switch(config-pmap)# class ipp5
Switch(config-pmap-c)# set cos dscp table dscp2Cos
Switch(config-pmap-c)# end
Switch# show policy-map p1
Policy Map p1
Switch# show table-map dscp2Cos
Table Map dscp2Cos
Configuring Policer Result-based Conditional Marking
To configure policer result-based conditional marking, setup a single rate or dual rate policer. Refer to
the "How to Implement Policing" section on page 44-52.
This example shows how to configure a two rate three-color policer with explicit actions for each policer
region:
Switch# configure terminal
Switch(config-pmap-c)# policer cir percent 20 pir percent 30
Switch(config-pmap-c-policer)# conform-action set-cos-transmit 3 set-dscp-transmit 10
Switch(config-pmap-c-policer)# exceed-action set-cos-transmit 4 set-dscp-transmit 20
Switch(config-pmap-c-policer)# violate action drop
Switch# show policy-map p1
Policy Map police
Marking Statistics
The marking statistics indicate the number of packets that are marked.
For unconditional marking, the classification entry points to an entry in the marking action table that in
turn indicates the fields in the packet that are marked. Therefore, the classification statistics by itself
indicates the unconditional marking statistics.
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
44-24
Class ipp5
set cos dscp table dscp2Qos
from 8 to 1
default copy
Class ipp5
police cir percent 20 pir percent 30
conform-action set-cos-transmit 3
conform-action set-dscp-transmit af11
exceed-action set-cos-transmit 4
exceed-action set-dscp-transmit af22
violate-action drop
Purpose
Verifies the configuration of the policy-map.
Verifies the configuration of the table-map.
Chapter 44
Configuring Quality of Service
Advertisement
Chapters
Table of Contents
Troubleshooting
