Configuring Module Modes On Ws-X4748-12X48U+E - Cisco Catalyst 4500 Series Software Configuration Manual
Cisco ios xe release 3.9.xe and cisco ios release 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages) ,
- Command reference manual (1230 pages)
Table of Contents
Advertisement
Table 9-3
Hardware and power supply not supported
Chassis Type
•
Cisco Catalyst 4507R-E
•
Cisco Catalyst 4510R-E
Configuring Module Modes on WS-X4748-12X48U+E
Note
This mode command is applicable only to the selected module. When the mode command is changed for
a module, the operation of other modules on the switch is not impacted.
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# hw-module module <slot> mode
<number>
Note
For the selected configuration to be applied, you must reset the module using the
module <slot> reset
To verify that the selected configuration is applied, enter the
The following example shows how to configure an Ethernet mode on WS-X4748-12X48U+E:
Switch(config)#hw-module module 3 mode ?
1 Multigigabit lite :12 MultiGigabit ports(10:1 oversubscribed) and 36 1Gigabit ports
2 Multigigabit enhanced :12 MultiGigabit ports(5:1 oversubscribed) and 24 1Gigabit ports
3 Multigigabit performance :12 MultiGigabit ports(2.5:1 oversubscribed) only
For information about setting interface speeds to 2.5G, 5G or 10G, see
Upgrading the Line Card FPGA Image on WS-X4748-12X48U+E
Beginning in Cisco IOS Release 3.7.1E, a new function to upgrade the line card FPGA on the WS-X4748-12X48U+E module
has been introduced to handle oversubscription on multigigabit ports. This upgrade capability allows feature updates or fixes
related to the line card FPGA on this module.
Note
Before you begin, download the new FPGA image to the bootflash, to a TFTP server, or to a USB drive.
Configuration for this module will be suspended during FPGA upgrade.The module is automatically
Caution
reset after the upgrade.
To upgrade the line card FPGA on WS-X4748-12X48U+E:
Configuring MultiGigabit Ports on WS-X4748-12X48U+E
Supervisor
•
Supervisor Engine 6-E, Supervisor
Engine 6L-E and earlier.
command.
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS
9
Purpose
Establishes global configuration mode.
Selects the configuration mode for the selected module.
command.
Switch#show module
Setting the Interface Speed, page
Chapter 9
Configuring Interfaces
Switch#hw-module
9-28.
Advertisement
Chapters
Table of Contents
Troubleshooting
