Setting The Operation Mode - Sony MVS-8000X User Manual
Multi format switcher system with ccp-9000 series center control panel
Hide thumbs
Also See for MVS-8000X:
- User manual (1310 pages) ,
- Installation manual (58 pages) ,
- Operation manual (26 pages)
Table of Contents
Advertisement
Notes
When the signal format is set to 720P, 1080PsF or 1080P,
this selection is not possible.
Setting the Operation Mode
In the <M/E Config> group of the Switcher >Config menu,
select the operation mode for each M/E or PGM/PST bank
from the following.
• Standard mode
• Multi Program mode
• DSK mode (PGM/PST only)
For details of the modes, see the explanation of the M/E
Config function (page 524).
Notes
When Multi Program mode is selected, two or more
transition type indication may light. It is also possible that
more than one "Transition Type" has been selected in the
Misc >Transition menu for each M/E.
Assigning the output of each bank in Multi
Program mode
When you selected [Multi Program] as the operation
mode, use the following procedure.
1
In the Switcher >Config menu, press [M/E Output
Assign].
The M/E Output Assign menu appears.
2
On the list in the status area, select the bank output to
be assigned.
The selected output appears in reverse video.
3
In the <M/E Output Assign> group, select the output
signal to be assigned.
Setting the output configuration for each
bank
When you selected [Multi Program] or [DSK] as the
operation mode, use the following procedure.
1
In the Switcher >Config menu, press [PGM Config].
The PGM Config menu appears.
The status area shows the background and key
configuration assigned to the output of each bank.
2
Using either of the following methods, select the
output for which you want to make the setting.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
1
No (PGM)
Output to which
setting applies
The selected output appears in reverse video.
3
In the <Bkgd> group, select the background.
In Multi Program mode, select [Clean] or [Utility2],
then skip to step 5.
In DSK mode, select one of [Bkgd1] to [Bkgd4].
4
In DSK mode, turn the knobs to select the background
signal.
Knob Parameter Adjustment
2 to 5 Bkgd1 to 4 Background
signal selection
a) 1 to 6: M/E1 OUT1 to 6
7 to 12: M/E2 OUT1 to 6
13 to 18: M/E3 OUT1 to 6
19 to 24: M/E4 OUT1 to 6
5
In each of the <Key1> to <Key8> groups, select
[Enable] or [Disable].
Setting the key preview configuration
You can make this setting at any time, regardless of the
operation mode.
1
In the Switcher >Config menu, press [K-PVW
Config].
The K-PVW Config menu appears.
The status area shows the key preview configuration
for each bank.
2
Using either of the following methods, select the key
preview to which the settings apply.
• Press directly on the list in the status area to make the
selection.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
1
No (K-
Key preview to
PVW)
which setting
applies
The selected key preview appears in reverse video.
Settings for Switcher Configuration (Config Menu)
Setting values
1 to 20
Setting values
a)
1 to 24
Setting values
1 to 10
525
Advertisement
Table of Contents
