Checking The Side Discharge Chute; Checking The Engine Oil Level; Installing The Seat; Checking The Tire Pressure - Toro TimeCutter 74502 Setup Instructions
Z riding mower
Hide thumbs
Also See for TimeCutter 74502:
- Operator's manual (40 pages) ,
- Operator's manual (40 pages)
Advertisement
1
2
3
Figure 3
1. Control arm
2. Bolt, 3/8 x 1 in.
3. Position the levers so that the bolts are in the center of
the slots on the lever mounting plate and tighten the
bolts until they are snug.
4. Align the front/rear position of the levers with each
other while in the neutral position. Loosen the bolts
and adjust the levers by sliding and/or tilting the
lever(s) forward or backward until they are properly
aligned.
5. If the ends of the motion control levers hit against each
other while they are in the drive position (Fig. 4) (the
levers are rotated in as far as possible), make
adjustments by moving the levers outward to the
neutral lock position and carefully bend them outward.
Move them back to the drive position and check for
clearance. Repeat if necessary.
Figure 4
Installing the Seat
1. Cut the plastic ties securing the seat to the machine for
shipping. Remove the seat.
2. Remove the knobs and flat washers (5/16 in.) from the
bottom of the seat.
3. Raise the seat support on the machine (Fig. 5).
4
m–5215
3. Curved washer, 3/8 in.
4. Control arm shaft
4. Slide the shoulder bolts on the bottom of the seat into
the slots on the seat support (Fig. 5). Secure the seat to
the seat support with the flat washers and knobs
removed in step 2 (Fig. 5).
2
3
1
Figure 5
1. Seat support
2. Shoulder bolt
5. Lower the seat and adjust it if necessary; refer to
Positioning the Seat in the Operator's Manual.
Checking the Mower
Adjustment
The mower deck was leveled at the factory. If the mower
is not cutting level, adjust the side-to-side level and the
front-to-rear blade slope. See the Operator's Manual for
the proper procedure.
Checking the Side Discharge
Chute
Remove the plastic tie holding the side discharge chute
up, and lower the chute into place.
Checking the Engine Oil Level
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Checking the
Oil Level in the Operator's Manual.
Checking the Tire Pressure
Check the front and rear tires for proper inflation. Refer to
Tire Pressure in the Operator's Manual for the
recommended inflation pressure.
3
m–5579
3. Knob
Advertisement
