Checking The Running Configuration Settings - Cisco ASR 902U Hardware Installation Manual
Hide thumbs
Also See for ASR 902U:
- Hardware installation manual (39 pages) ,
- Troubleshooting manual (18 pages)
Table of Contents
Advertisement
Checking the Running Configuration Settings
When you see this information, it means that you have successfully booted your router:
Example:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Press RETURN to get started!
Step 2
The first sections of the configuration script appear only at an initial system startup. On subsequent uses of the setup
facility, the script begins with a System Configuration Dialog as shown below: When you are prompted about whether
you want to enter the initial configuration dialog, enter yes.
Example:
Would you like to enter the initial configuration dialog? [yes/no] yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system, extended
setup will ask you
to configure each interface on the system.
Basic management setup configures enough connectivity for managing the system; extended setup will ask you to
configure each interface on the system. For detailed information about setting global parameters, refer to the
900 Series Router Software Configuration
Checking the Running Configuration Settings
To check the value of the settings you have entered, enter the show running-config command at the Router#
prompt:
Router# show running-config
To review changes you make to the configuration, use the EXEC mode show startup-config command to
see the changes and copy run-start stored in NVRAM.
Cisco ASR 902 and ASR 902U Aggregation Services Router Hardware Installation Guide
118
Guide.
Cisco Router Initial Configuration
Cisco ASR
Advertisement
Table of Contents
