Installing The Cable Connector - Cisco ASR 902U Hardware Installation Manual
Hide thumbs
Also See for ASR 902U:
- Hardware installation manual (39 pages) ,
- Troubleshooting manual (18 pages)
Table of Contents
Advertisement
Installing the Cisco ASR 902 Router
A patch panel is required in order to connect the high-density interface connector to individual T1/E1
Note
lines.
Figure 58: T1/E1 Cable Connector
Installing the Cable Connector
One end of the cable has a 100-pin connector that plugs into the T1/E1 interface module. Use the thumbscrews
on either side of the connector to secure the cable to the interface.
The other end of the cable has two 50-pin Telco connectors that are attached to the rear of a 24-port RJ45
patch panel. Both connectors are identical: one is for Transmit (TX) and the other is for Receive (RX).
Cisco ASR 902 and ASR 902U Aggregation Services Router Hardware Installation Guide
Connecting T1/E1 Cables
107
Advertisement
Table of Contents
