Table of Contents
Advertisement
i When recording, slide and hold this switch
toward 0REC for about one second to stop
recording.
NOTE
The one-second delay is intended to prevent
accidental operation.
PHONES [+]/[−] buttons
w
Use the + and − buttons to adjust the volume
output from the headphones jack.
During adjustment, a volume indicator will
appear on the display.
Large
Small
CAUTION
Before connecting headphones, lower the
PHONES volume to the minimum level. Failure
to do so might cause sudden loud noises, which
could harm your hearing or result in other
trouble.
Do not apply excessive force to the jack when
connecting and using headphones. Be careful,
because the application of unintended force,
particularly when using a mini jack, could
damage the equipment.
8
TASCAM DR-10L
Top
e 1/8" (3.5mm) mini TRS (with screw lock) IN
jack
Connect the 3.5mm plug of the mic being used
to this unit's IN jack.
After connecting it, lock the connector of the
mic cable using the jack screw lock.
(Tip: MIC (BIAS), Ring: Open, Sleeve: GND)
NOTE
Avoid excessive force on this connector.
Preparation
Power sources
This unit can operate on one AAA battery or USB bus
power using the included USB cable.
This unit can use an alkaline, Ni-MH or lithium AAA
battery.
Using a AAA battery
Open the battery compartment cover on the back
of the unit. Install 1 AAA battery in the compartment
with the ¥ and ^ marks as shown. Then, close the
battery compartment cover.
When using a AAA battery, set the type of battery
in order to accurately show the amount of power
remaining and allow the unit to accurately determine
whether power is available for proper operation. (See
"Making menu settings" on page 12.)
CAUTION
• AAA manganese dry cell batteries cannot be
used with this unit.
• This unit cannot recharge AAA Ni-MH batteries.
Use a commercially-available recharger.
Hide quick links:
Advertisement
Table of Contents
