Adding A Vtp Client Switch To A Vtp Domain - Cisco Catalyst 3750-E Software Configuration Manual
Hide thumbs
Also See for Catalyst 3750-E:
- Getting started manual (27 pages) ,
- Product support bulletin (6 pages) ,
- Configuration handbook (359 pages)
Table of Contents
Advertisement
Configuring VTP
Configuring VTP on a Per-Port Basis
With VTP version 3, you can enable or disable VTP on a per-port basis. You can enable VTP only on
ports that are in trunk mode. Incoming and outgoing VTP traffic are blocked, not forwarded.
Beginning in privileged EXEC mode, follow these steps to enable VTP on a port:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
vtp
Step 4
end
Step 5
show running-config interface
interface-id
Step 6
show vtp status
To disable VTP on the interface, use the no vtp interface configuration command.
Switch(config)# interface gigabitethernet 1/0/1
Switch(config-if)# vtp
Switch(config-if)# end
Adding a VTP Client Switch to a VTP Domain
Before adding a VTP client to a VTP domain, always verify that its VTP configuration revision number
is lower than the configuration revision number of the other switches in the VTP domain. Switches in a
VTP domain always use the VLAN configuration of the switch with the highest VTP configuration
revision number. With VTP versions 1 and 2, adding a switch that has a revision number higher than the
revision number in the VTP domain can erase all VLAN information from the VTP server and VTP
domain. With VTP version 3, the VLAN information is not erased.
Beginning in privileged EXEC mode, follow these steps to verify and reset the VTP configuration
revision number on a switch before adding it to a VTP domain:
Command
Step 1
show vtp status
Step 2
configure terminal
Step 3
vtp domain domain-name
Step 4
end
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
14-16
Purpose
Enter global configuration mode.
Identify an interface, and enter interface configuration mode.
Enable VTP on the specified port.
Return to privileged EXEC mode.
Verify the change to the port.
Verify the configuration.
Purpose
Check the VTP configuration revision number.
If the number is 0, add the switch to the VTP domain.
If the number is greater than 0, follow these steps:
Write down the domain name.
a.
Write down the configuration revision number.
b.
Continue with the next steps to reset the switch configuration revision number.
c.
Enter global configuration mode.
Change the domain name from the original one displayed in Step 1 to a new name.
The VLAN information on the switch is updated and the configuration revision
number is reset to 0. You return to privileged EXEC mode.
Chapter 14
Configuring VTP
OL-9775-08
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
