Connect Console Port To Terminal Server - Cisco ASR 5500 Installation Manual
Hide thumbs
Also See for ASR 5500:
- System administration manual (430 pages) ,
- Administration manual (410 pages) ,
- Installation manual (192 pages)
Table of Contents
Advertisement
▀ Console Port
Connect Console Port to Terminal Server
You can connect the terminal server to a serial port on a terminal server.
Important:
Flow control must be disabled on the connected equipment.
To connect a terminal server to the Console port, do the following:
Step 1
Plug one end of an RJ45 cable to the port labeled Console on the MIO or UMIO.
Step 2
Plug the other end of the RJ45 cable into a port on the terminal server.
Step 3
Configure the communications protocol on the terminal server port to support the following:
Baud Rate = 115200 bps
Data Bits = 8
Parity = None
Stop Bits = 1
Flow Control = None
Important:
asynchronous interface modules, refer to the Console Port to Cisco Server Cabling appendix.
▄ ASR 5500 Installation Guide
74
The Console port does not support flow control signaling required by some types of terminal servers.
For additional information on connecting the Console port to Cisco servers equipped with
MIO Port Cabling
Advertisement
Table of Contents
