Toro TimeCutter ZS 5000 Installation Instructions
Belt guard kit
Hide thumbs
Also See for TimeCutter ZS 5000:
- Operator's manual (64 pages) ,
- Operator's manual (56 pages) ,
- Operator's manual (52 pages)
Advertisement
Quick Links
Belt Guard Kit
TimeCutter
Model No. 120-7790
Do not supply these instructions to the customer.
These instructions are for a dealer to install additional belt guards on units sold in France.
Safety
Safety and Instructional
Decals
Safety decals and instructions are easily
visible to the operator and are located
near any area of potential danger.
Replace any decal that is damaged or
lost.
120-1119
1. Fire hazard—read the Operator's Manual.
© 2011—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
ZS 5000 Riding Mower
Installation
Preparing for Installation
No Parts Required
Procedure
Important: Refer to the Operator's Manual if you
are unfamiliar with the specifics of operating this
machine before proceeding. The manual contains
important information about safely operating the
machine. If you do not know this information, you
could seriously injure yourself or others.
1. Park the machine on a level, smooth surface with
2. Check the loose parts bag and verify that it contains
3. Remove the mowing deck and slide it out from
Register at www.Toro.com.
Installation Instructions
1
sufficient space to access both sides of the mowing
deck.
WARNING
Before working on the machine, stop the engine,
set the parking brake, remove the ignition key,
and disconnect the spark plug wire.
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect
the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does
not accidentally contact the spark plug.
all the parts listed in this document.
under the traction unit; refer to the Operator's Manual
for this model.
Form No. 3368-785 Rev A
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Advertisement
Related Manuals for Toro TimeCutter ZS 5000
Summary of Contents for Toro TimeCutter ZS 5000
-
Page 1: Safety And Instructional Decals
3. Remove the mowing deck and slide it out from under the traction unit; refer to the Operator’s Manual for this model. Register at www.Toro.com. © 2011—The Toro® Company Original Instructions (EN) 8111 Lyndale Avenue South Printed in the USA. - Page 2 Assembling the Deck Belt Installing the Deck Belt Guard Guard No Parts Required Parts needed for this procedure: Procedure Left deck guard plate 1. Loosen, but do not remove, the flange nut on the Right deck guard plate outside of each suspension bracket on the rear of the Top deck guard plate deck;...
- Page 3 Figure 3 1. Washer, existing 4. Rear slots, pair (2) 2. Knob, existing 5. Bolt, existing 3. Flange nut, existing (2) 6. Tab B. For each side of the guard, insert the previously loosened flange nut through the large opening and slide the bolt into the slot that fits best (Figure 3).