hit counter script

Advertisement

QQ
3 7 63 1515 0
SERVICE MANUAL
TE
L 13942296513
System
Laser: Semiconductor laser
Signal format system: PAL/NTSC
(See page 16 to switch)
Audio characteristics
Frequency response: DVD VIDEO (PCM
96 kHz): 2 Hz to 44 kHz (±1.0 dB)/
DVD VIDEO (PCM 48 kHz): 2 Hz to
22 kHz (±0.5 dB)/CD: 2 Hz to 20 kHz
(±0.5 dB)
Signal-to-noise ratio (S/N ratio): 115 dB
(LINE OUT L/R (AUDIO) jacks only)
Harmonic distortion: 0.003%
Dynamic range: DVD VIDEO: 103 dB/CD:
99 dB
Wow and flutter: Less than detected value
(±0.001% W PEAK)
www
.
http://www.xiaoyu163.com
Photo : DVP-K82P
RMT-D177P
Outputs and Input
(Jack name: Jack type/Output level/
Load impedance)
LINE OUT (AUDIO): Phono jack/
2 Vrms/ 10 kilohms
DIGITAL OUT (OPTICAL):
Optical output jack/-18 dBm
(wave length: 660 nm)
DIGITAL OUT (COAXIAL): Phono jack/
0.5 Vp-p/75 ohms
COMPONENT VIDEO OUT (K82P)
(Y, P
Y: 1.0 Vp-p, P
P
/C
R
COMPONENT VIDEO OUT
(Y, P
Phono jack/Y: 1.0 Vp-p/P
interlace
interlace
*1
BLACK LEVEL
(COMPONENT OUT) is ON
*2
BLACK LEVEL
(COMPONENT OUT) is OFF
LINE OUT (VIDEO): Phono jack/
1.0 Vp-p/75 ohms
x
ao
u163
y
i
http://www.xiaoyu163.com
DVP-K80P/K82P
2 9
8
Q Q
3
6 7
1 3
1 5
SPECIFICATIONS
/C
, P
/C
): Phono jack/
B
B
R
R
/C
,
B
B
: 0.7 Vp-p/75 ohms
R
, P
) (K80P)
B
R
, P
:
B
R
*1
= 0.648 Vp-p, progressive or
*2
= 0.7 Vp-p/75 ohms
co
.
9 4
2 8
RMT-D177A/RMT-D177P
Brazilian Model
E Model
Chinese Model
Russian Model
Saudi Arabia Model
Singapore Model
0 5
8
2 9
9 4
2 8
S VIDEO OUT: 4-pin mini DIN/
Y: 1.0 Vp-p, C: 0.3 Vp-p (PAL),
0.286 Vp-p (NTSC)/75 ohms
MIC input 1/2: Phone jacks
General
Power requirements:
110–240 V AC, 50/60 Hz
(Except K82P: RUS)
220–240 V AC, 50/60 Hz
(K82P: RUS)
Power consumption: 11 W
Dimensions (approx.):
430 × 55.5 × 243.7 mm
(width/height/depth)
incl. projecting parts
Mass (approx.): 2.04 kg
Operating temperature: 5°C to 35°C
Operating humidity: 25% to 80%
Supplied accessories
See page 14.
Specifications and design are subject to
change without notice.
m
CD/DVD PLAYER
9 9
DVP-K80P
DVP-K82P
9 9

Advertisement

Table of Contents
loading

Summary of Contents for Sony DVP-K80P

  • Page 1 DVP-K80P/K82P 3 7 63 1515 0 RMT-D177A/RMT-D177P Brazilian Model SERVICE MANUAL E Model DVP-K80P Chinese Model Russian Model Saudi Arabia Model Singapore Model DVP-K82P Photo : DVP-K82P RMT-D177P L 13942296513 SPECIFICATIONS System Outputs and Input S VIDEO OUT: 4-pin mini DIN/...
  • Page 2: Overall Block Diagram

    DVP-K80P/K82P SECTION 3 3 7 6 3 1 5 1 5 0 BLOCK DIAGRAMS 3-1. OVERALL BLOCK DIAGRAM RV501 RV503 RV502 J502 J501 ECHO VR MIC VR MIC VR MIC IN 2 MIC IN 1 IC501 IC504 IC505 IC502...
  • Page 3: Power Line Block Diagram

    DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 3-2. POWER LINE BLOCK DIAGRAM POWER BOARD (SRV1501WW) MV-045 BOARD (SEE PAGE 4-29 to 4-32) (SEE PAGE 4-5 to 4-16) T101 D411 L421 Q211 D211 L211 P.CONT Video Buffer...
  • Page 4: System Control/Signal Processor Block Diagram

    DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 3-3. SYSTEM CONTROL/SIGNAL PROCESSOR BLOCK DIAGRAM MV-045 BOARD (SEE PAGE 4-7 to 4-8) IC104 IC102 64M SDRAM 16M ROM 146,147,149~151,158~160 115,117,118,120,121,123~126,128~133,135 142 156 157 113 137 53~61,67~72,74~76,78,89,92,93 81~84,86~88,91 IOOE...
  • Page 5: Rf/Servo Block Diagram

    DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 3-4. RF/SERVO BLOCK DIAGRAM MV-045 BOARD (SEE PAGE 4-9 to 4-10) BASE UNIT (DEVICE, OPTICAL KHM-310CAA/C2RP) CN201 SLED 28 D04+ MOTOR D04- 30 D03+ IN1- SPINDLE IN2- D03- MOTOR...
  • Page 6: Audio Block Diagram

    DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 3-5. AUDIO BLOCK DIAGRAM MC-155 BOARD (SEE PAGE 4-21 to 4-24) RV501 RV503 RV502 J502 J501 ECHO VR MIC VR MIC VR MIC IN 2 MIC IN 1 IC504...
  • Page 7: Video Block Diagram

    DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 3-6. VIDEO BLOCK DIAGRAM MV-045 BOARD IC304 wl (SEE PAGE 4-11 to 4-12) IC304 VIDEO BUFFER MUTE 2.0Vp-p J501 VIDEO IN VIDEO OUT COMBO JACK IC304 wj Y IN...
  • Page 8: Interface Control Block Diagram

    DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 3-7. INTERFACE CONTROL BLOCK DIAGRAM IF-131 BOARD (SEE PAGE 4-19 to 4-20) CN401 IC 407 SW-10V EVER+5V 3.3V REGULATOR SW+3.3V SYSRST D401 SYSRST PROG LED XIFCS EVER+3.3V SYSTEM CONTROL...
  • Page 9: Section 4 Printed Wiring Boards And Schematic Diagrams

    DVP-K80P/K82P SECTION 4 3 7 6 3 1 5 1 5 0 PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS 4-1. FRAME SCHEMATIC DIAGRAM 1-963-090-11 HARNESS 1-963-597-11 CN201 PM-119 CN501 MC-086 SW+8V SW+8V HARNESS MTR GND MTR GND EVER+11V EVER+11V EVER+5V...
  • Page 10 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 4-3. WAVEFORM 4-2. PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS THIS NOTE IS COMMON FOR WIRING BOARDS AND SCHEMATIC DIAGRAMS. MV-045 BOARD (In addition to this, the necessary note is printed in each block)
  • Page 11 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 MV-045 (CPU, Servo-DSP, AVDEC, DRIVE, VIDEO, AUDIO, POWER) PRINTED WIRING BOARD • : Uses unleaded solder. MV-045 BOARD MV-045 BOARD SIDE A MV-045 BOARD SIDE B SIDE A SIDE B...
  • Page 12: Cpu, Servo-Dsp, Avdec

    DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 For Schematic Diagram • Refer to page 4-5 for printed wiring board of MV-045 board. • Refer to page 4-4 for waveform MV-045 BOARD (1/5) CPU, Servo-DSP, AVDEC -REF.NO.:1000 SERIES-...
  • Page 13 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 For Schematic Diagram • Refer to page 4-5 for printed wiring board of MV-045 board. • Refer to page 4-4 for waveform MV-045 BOARD (2/5) DRIVE -REF.NO.:1000 SERIES- XX MARK:NO MOUNT...
  • Page 14 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 For Schematic Diagram • Refer to page 4-5 for printed wiring board of MV-045 board. • Refer to page 4-4 for waveform MV-045 BOARD (3/5) VIDEO -REF.NO.:1000 SERIES- XX MARK:NO MOUNT...
  • Page 15 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 For Schematic Diagram • Refer to page 4-5 for printed wiring board of MV-045 board. • Refer to page 4-4 for waveform MV-045 BOARD (4/5) AUDIO -REF.NO.:1000 SERIES- XX MARK:NO MOUNT...
  • Page 16 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 For Schematic Diagram • Refer to page 4-5 for printed wiring board of MV-045 board. • Refer to page 4-4 for waveform MV-045 BOARD (5/5) POWER -REF.NO.:1000 SERIES- XX MARK:NO MOUNT...
  • Page 17 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 IF-131 (IF) PRINTED WIRING BOARD • : Uses unleaded solder. For printed wiring board IF-131 BOARD SIDE A There are a few cases that the part printed on this diagram isn’t mounted in this model.
  • Page 18 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 For Schematic Diagram • Refer to page 4-17 for printed wiring board of IF-131 board. IF-131 BOARD -REF.NO.:1000 SERIES- XX MARK:NO MOUNT NO MARK:PB MODE MARKED:MOUNT TABLE 1 3 9 4 2 2 9 6 5 1 3...
  • Page 19 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 MC-155 (MIC-ECHO) PRINTED WIRING BOARD • : Uses unleaded solder. For printed wiring board MC-155 BOARD SIDE A There are a few cases that the part printed on this diagram isn’t mounted in this model.
  • Page 20 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 For Schematic Diagram • Refer to page 4-21 for printed wiring board of MC-155 board. MC-155 BOARD MIC-ECHO -REF.NO.:1000 SERIES- XX MARK:NO MOUNT NO MARK:PB MODE MARKED:MOUNT TABLE 1 3 9 4 2 2 9 6 5 1 3...
  • Page 21: Key Control

    DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 CK-151 (KEY CONTROL) PRINTED WIRING BOARD • : Uses unleaded solder. For printed wiring board CK-151 BOARD SIDE A There are a few cases that the part printed on this diagram isn’t mounted in this model.
  • Page 22 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 For Schematic Diagram • Refer to page 4-25 for printed wiring board of CK-151 board. CK-151 BOARD KEY CONTROL -REF.NO.:1000 SERIES- XX MARK:NO MOUNT NO MARK:PB MODE MARKED:MOUNT TABLE...
  • Page 23: Power Board

    DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 POWER BLOCK (SRV1501WW) PRINTED WIRING BOARD • : Uses unleaded solder. POWER BOARD (SRV1501WW) (SIDE A) For printed wiring board There are a few cases that the part printed on this diagram isn’t mounted in this model.
  • Page 24 DVP-K80P/K82P 3 7 6 3 1 5 1 5 0 For Schematic Diagram • Refer to page 4-29 for printed wiring board of Power Board. POWER BOARD POWER BLOCK (SRV1501WW) -REF.NO.:1000 SERIES- XX MARK:NO MOUNT NO MARK:PB MODE MARKED:MOUNT TABLE...

This manual is also suitable for:

Rmt-d177pDvp-k82pRmt-d177a

Table of Contents