Configuring Ais Shut - Cisco ASR 900 Series Configuration Manual
Interface module configuration
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (152 pages)
Table of Contents
Advertisement
Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
Configuring AIS Shut
To configure AIS-Shut:
enable
configure terminal
controller sdh 0/5/0
ais-shut
end
The no ais-shut command does not send AIS.
Note
Shutdown
Disables the interface.
Configuring Shut
To configure Shut:
enable
configure terminal
controller sdh 0/5/0
shutdown
end
Note
Use the no shutdown command to disable the interface.
Alarm Reporting
Enables reporting for all or selected alarms.
• b1-tca — Enables BER threshold crossing alarm for B1.
• b2-tca — Enables BER threshold crossing alarm for B2.
• b3-tca — Enables BER threshold crossing alarm for B3.
• lais —Enables line alarm indication signal.
• lom — Enables loss of multiframe signal.
• lrdi — Enables line remote defect indication signal.
• pais — Enables path alarm indication signal.
• plop — Enables loss of pointer failure signal for a path.
• pplm — Enables path payload mismatch indication.
• prdi — Enables path remote defect indication signal.
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Shutdown
ASR 900 Series)
91
Advertisement
Table of Contents
