Page 1
E5 is processing data services for a long period, due to the E5 not being able to dissipate the heat effectively. If this happens and as a safety precaution the E5 will switch off automatically or disconnect.
Page 2
Get to Know Your E5 Appearance Item Screen Micro SD card slot USB connector Power On/Off WiFi/WPS button Dialing button Strap hole Battery_button WiFi: Wireless Fidelity...
Page 3
WPS: WiFi Protected Setup Screen Item Signal strength Network WiFi enabled The number of connected devices Internet connection New messages The number of new messages Battery power level Roaming status M: Manual mode...
Install the SIM Card and Battery Position the card at the card slot entrance, making sure it is facing the same way as shown in the diagram, with the notched corner at the top left. Then slide in.
Page 6
How to Access the Internet with WiFi Note: By default, the management parameters are preset on the E5 according to the requirements from the service provider. You can follow the steps below to quickly access the Internet. For the details about how to set the management parameters, see the Help on the Web management page.
Page 7
E5 is powered on. Note: Press and hold until the screen is off; the E5 is powered off. 2. Establish the WiFi Connection (Take PC for Example) Make sure that the WiFi is enabled. Select Start > Control Panel >...
Page 8
The SSID and key label is attached on the E5. Wait for a while. The wireless connection icon displays in the status area in the lower right corner of the screen. Then, your PC can connect to the E5.
Internet using the following two modes. By default, the mode is On Demand. Mode Operations After the E5 is powered on, it can automatically connect Demand to the Internet when data transmission is required. If data transmission is not performed over a period of time, the E5 automatically tears down the Internet connection.
Page 10
You can launch the web management page to select the mode of accessing the Internet. If the E5 accesses the roaming network, the E5 automatically tears down the established network connection. While in the roaming network, you can only press and hold...
Page 11
How to Access the Web Management Page Make sure that the connection between the E5 and the WiFi device or computer is normal. Start the Internet browser and enter http://192.168.1.1 in the address bar. Enter the password, and then click Login.
E5 model. Using charger of other device model, other manufacturers or vendors may invalidate any approval or warranty applicable to the E5, result in the non-operation of the E5, and cause danger. Charger is an optional accessory. If the charger is not provided in the package, you can contact your service provider to buy one yourself.
Page 13
Connect the E5 and PC with the compatible data cable. Saving Power mode If the E5 has not been carried out any operations for a while, the screen is off. If the E5 has not been accessed for 10 minutes by default, the E5 changes to the deep sleep state.
Page 14
WiFi is disabled. Establishing the WPS Connection If the WiFi Clients connected with the E5 support the WPS, the E5 can automatically generate a network key without manually entering. The operation steps of WPS connection are as follows.
Page 15
Management Page ”. Multi-device Access The WiFi device or computer can be connected to the Internet through the E5. The actual connecting procedure depends on the operating system of the WiFi device or computer. Follow the prompts to perform the connecting operations.
Do not remove the card when it is being used. Removing the card during an operation may damage the card as well as the E5, and data stored on the card may be corrupted. Restoring the Factory Defaults...
Page 19
Friendly Tips If you cannot use the E5 normally, you can try these following ways to solve: See Help on the web management page. Restart the E5.
Page 20
Version: V100R001_01 Part Number: 31010CBT...