Default Configuration Values For Channelized Sonet/Sdh - Cisco ASR 9000 Series Configuring
Configuring channelized sonet/sdh
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Information About Configuring Channelized SONET/SDH
Figure 27
The 1-Port Channelized OC-48/STM-16 SPA only supports channelization to the T3 or E3 level. Further
Note
channelization of AU-4 paths is not supported.
Figure 27
Default Configuration Values for Channelized SONET/SDH
Table 3
Table 3
Parameter
Clock source
SONET framing
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
HC-326
shows the SDH AU4 paths that can be configured on supported SPAs.
SDH AU4 Paths
SONET
Controller
AU-4
STM-1
describes the default configuration parameters that are present on the Channelized SONET/SDH.
SONET/SDH Controller Default Cit onfiguration Values
Default Value
line
sonet
Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
TUG-3
T3
or C12
Configuration File Entry
clock source {internal | line}
framing {sdh | sonet}
E1
E1
E1
E1
E1
Up to 21 E1s
E1
E1
E1
E1
E1
OL-26061-03
Advertisement
Table of Contents
