General Safety Guidelines - Cisco ASR 9901 Manual

Hide thumbs Also See for ASR 9901:

Hardware installation manual (158 pages)

Installation manual (284 pages)

Table Of Contents

Table of Contents

Preparing for Installation

Cisco ASR 9001-S Router

The Cisco ASR 9001-S Router is a 60 Gbps variant of the Cisco ASR 9001 Router. Similar to other routers

in the Cisco ASR 9000 Series, running Cisco IOS XR software images, the Cisco ASR 9001-S Router delivers

the features and services found on the ASR 9000 Series platforms, allowing customers to standardize on the

same Cisco IOS XR image. The Cisco ASR 9001-S Router comes standard with one modular bay (BAY 0)

that supports either a 1 GE, 10 GE, or 40 GE modular port adapters (MPAs). The chassis also comes usable

with two fixed SFP+ ports (SFP+0 and SFP+1). The second MPA slot (BAY 1) and other two SFP+ ports

(SFP+2 and SFP+3) are disabled and covered with dust caps by default. It supports the same set of features

and scaling for each NPU as does the Cisco ASR 9001 Router. The following figure shows the front panel of

the Cisco ASR 9001-S Router.

Figure 3: Front Panel of the Cisco ASR 9001-S Router

In order to achieve the full bandwidth of 120 Gbps and to enable the disabled ports, a Cisco license can be

obtained. Once the license is obtained and installed, the Cisco ASR 9001-S Router must be reloaded to bring

up the full 120 Gbps capacity. For information on configuring the Cisco license for Cisco ASR 9001-S Router,

see the

Note

The Cisco ASR 9001-S Router follows the same hardware installation procedure as the procedure for the

Cisco ASR 9001 Router, described in this document.

Safety Guidelines

Before you perform any procedure in this publication, you must review the safety guidelines in this section

to avoid injuring yourself or damaging the equipment.

Note that this section contains guidelines, and do not include every potentially hazardous situation. When you

install a router, always use caution and common sense.