Removing Door - Sanyo EM-F3400SW Service Manual
Sanyo microwave oven service manual
Hide thumbs
Also See for EM-F3400SW:
- Supplement of service manual (36 pages) ,
- Supplement of service manual (36 pages)
Table of Contents
Advertisement
H. H.
H. H. REMOVING DOOR
REMOVING DOOR
REMOVING DOOR
REMOVING DOOR
H.
REMOVING DOOR
(1) Remove 2 hex nuts securing the upper hinge.
(2) Tilt the top of the door toward you.
(3) Lift up the door to remove it.
NOTE
NOTE
NOTE
NOTE
NOTE
- After replacing the door, be sure to check that the
primary interlock switch, the door sensing switch
and the interlock monitor switch operate normally.
(See page 1).
- After replacing the door, check for microwave energy
leakage with a leakage detector. Microwave energy
leakage must be below the limit of 4mW/cm
allow for measurement uncertainty.
I. I. I. I. I. DISASSEMBLING DOOR
DISASSEMBLING DOOR
DISASSEMBLING DOOR
DISASSEMBLING DOOR
DISASSEMBLING DOOR
(Figure 15)
(1) Insert a thin flat-blade screwdriver between the
choke dielectric and the door main frame and lift
up the choke dielectric to release hooks one by
one. (Figure 15).
(2) Remove the choke dielectric.
(3) To detach the door cover, insert a thin flat-blade
screwdriver between door cover and door panel
and release the projections inside door cover.
(4) To detach the door panel, insert a thin flat-blade
screwdriver between the door cover and door
main frame.
Hooks
Door
Main
Frame
Choke
Dielectric
NOTE
NOTE
NOTE
NOTE
NOTE
- The choke dielectric may be damaged when
it is removed. When reinstalling it replace it
with new ones if it is damaged.
- After installing the door in place, check for
microwave energy leakage with a detector.
Microwave energy leakage must be below the
limit of 4mW/cm
2
to allow for measurement
uncertainty.
2
to
Hooks
Hooks
Hooks
Figure 15
Figure 15
Figure 15
Figure 15
Figure 15
- 14 -
J. J. J. J. J. REMOVING CA
REMOVING CA
REMOVING CA
VITY COVER
VITY COVER
REMOVING CAVITY COVER
REMOVING CA
VITY COVER
VITY COVER
(Figure 16)
(1) Remove a screw from the cavity compartment.
Cavity Cover
Screw
Figure 16
Figure 16
Figure 16
Figure 16
Figure 16
K. K. K. K. K. REMOVING TURNT
REMOVING TURNT
REMOVING TURNT
REMOVING TURNT
REMOVING TURNTABLE MOTOR COVER
(Figure 17)
(1) Turn over the oven on its back.
(2) Cut the 6-joints of the bottom plate using diagonal
pliers (nipper).
(3) Separate the motor cover from bottom plate.
(4) Remove 2 screws securing turntable motor to the
cavity and take it out.
Note
Note : Bent the cut joints inside slightly for safety
Note
Note
Note
and be careful of sharp edge.
6 Joints
Figure 17
Figure 17
Figure 17
Figure 17
Figure 17
ABLE MOTOR COVER
ABLE MOTOR COVER
ABLE MOTOR COVER
ABLE MOTOR COVER
Motor Cover
Bottom Plate
Hide quick links:
Advertisement
Table of Contents
