Sanyo LNS-M01 Replacement Procedure

Lcd projector lens

Download this manual

LCD PROJECTOR LENS

MODEL NO. LNS-M01

LENS REPLACEMENT AND

INSTALLATION PROCEDURE

Lens installation should be performed by the qualified service personnel.

It should be followed by this procedure precisely.

Before attempt to install the lens, confirm the model number (both the LCD

projector and the lens) and use the proper lens.

If you have any questions, contact to the dealers.

Following checks and confirmations should be taken for safety.

Check the following things by the time of the cabinet assembly after the

lens installation.

1. Confirm the lens is securely fixed by 4 screws.

2. Wiring must not be tangled in the gear of the lens motor or the other

mechanical part.

3. There is no missing part, or no loosing mounting part.

LNS-S01

NOTES ON LENS INSTALLATION

PARTS LIST

Following parts are contained in the packing.

· LENS

· LENS MOUNTING SCREWS

· DRIVER

· LIGHT-BLOCK SHEET

1 piece

6 screws (2 for spare)

1 piece

1 sheet

1AA6P1P1980-- (ICPP)

Page 1: Parts List
LCD PROJECTOR LENS MODEL NO. LNS-M01 LNS-S01 LENS REPLACEMENT AND INSTALLATION PROCEDURE NOTES ON LENS INSTALLATION Lens installation should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to install the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens.
Page 2 LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps REMOVE THE LENS COVER. (See figure-1) Remove screws A (2 screws). Pull down the lower lens cover while pushing the part D, then remove it. Remove screws B (2 screws). Remove screws C (2 screws) and remove upper lens cover.
Page 3 INSTALL THE LENS. (See figure-4,5.) 1. Mount the lens at the lens mounting bracket with screws (4 screws) included with the lens. Use the driver included with the lens to fasten the screws . (After using, save it for latter use.) 2.

Lns-s01