Table of Contents
Advertisement
CLEARANCES AND DIMENSIONS
• Dimensions that are shown in Figure 1 must be used. Given
dimensions provide minimum clearance. Locate electrical
outlet in the shaded area in the upper left-hand corner of the
cutout. See Figure 9.
• Contact surface must be solid and level. Pay special attention
to the floor on which the Microwave Drawer will sit. The
floor of the opening should be constructed of plywood strong
enough to support the weight of the oven (about 100 pounds).
• Check location where the Microwave Drawer will be
installed for proper electrical supply.
24" MICROWAVE DRAWER STANDARD MOUNT AND MEASUREMENTS
B
M
G
I
J
L
O
Figure 1
A. 6" (152.40 mm)
B. Suggested electrical
outlet location*
C. Anti-Tip block
D. 5" (127 mm)
E. 3-1/2" (88.90 mm)
F. 4" (101.60 mm)
G. 22-1/8" (561.97 mm)
opening
H. 14-13/16" (376.24 mm) to
bottom of Anti-Tip block
I. Allow 7/8" (22.22 mm)
overlap
E
A
D
F
K
P
I
J. 23-1/2" (596.90 mm)
minimum depth
K. Allow 7/16" (11.11 mm)
overlap
L. 36" (914.40 mm)
countertop height
M. Allow 7/16" (11.11 mm)
minimum space
N. Floor must support 100 lb
(45.4 kg)
O. 24" (609.60 mm) cabinet
minimum
P. 15-9/16" (395.29 mm)
opening
• Your oven can be built into a cabinet or wall by itself or
under a gas or electric wall oven.
• Be sur e that the clearance of the floor between the wall oven
and the microwave drawer is a minimum of 2-inches.
• The microwave interior will easily accommodate a 9" x 13"
oblong dish or a bag of microwave popcorn.
• The oven can also be mounted flush. Please see instructions
for flush m ounting.
C
E
F
H
E
N
Figure 2
A. 21-5/8" (549.28 mm)
B. 4-11/16" (119.06 mm)
C. 1-3/4" (44.45 mm)
D. 21-7/8" (555.63 mm)
E. 23-5/8" (600.07 mm)
Figures 1 and 2 contain many Microwave Drawer measurements
for reference when planning the drawer's location.
This Microwave Drawer can be installed below any electric or
gas wall oven.
* Can also be installed using an electrical outlet in an adjacent cabinet
within the area where the provided electrical cord can reach. Power
cord access hole in cabinet should be a minimum 1 1 /2" diameter
hole and deburred of all sharp edges.
IMPORTANT
electrical outlet to prevent tension.
Always check electrical codes for requirements.
2
B
C
B
J
C
D
E
F. 16" (406.4 mm)
G. 14-19/32" (370.68 mm)
H. 1-17/32" (38.89 mm) door thickness
I. 15" (381 mm) auto drawer opening
J. 4" (101 mm)
Always allow sufficient power cord length to the
A
A
G
I
D
H
F
G
Advertisement
Table of Contents
