Table of Contents
Advertisement
Configuring the CoPP Scale Factor Per Line Card
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Related Topics
Configuring a Control Plane Policy Map, on page 129
Configuring the CoPP Scale Factor Per Line Card
You can configure the CoPP scale factor per line card.
The scale factor configuration is used to scale the policer rate of the applied CoPP policy for a particular line
card. The accepted value is from 0.10 to 2.00. You can increase or reduce the policer rate for a particular line
Cisco Nexus 3600 NX-OS Security Configuration Guide, Release 7.x
132
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
control-plane
Example:
switch(config)# control-plane
switch(config-cp)#
[no] service-policy input policy-map-name
Example:
switch(config-cp)# service-policy
input PolicyMapA
exit
Example:
switch(config-cp)# exit
switch(config)#
show running-config copp [all]
Example:
switch(config)# show running-config
copp
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
Configuring Control Plane Policing
Purpose
Enters global configuration mode.
Enters control plane configuration mode.
Specifies a policy map for the input traffic. Repeat
this step if you have more than one policy map.
You cannot disable CoPP. If you enter the no form
of this command, packets are rate limited at 50
packets per seconds [for releases prior to Cisco
NX-OS Release 7.0(3)I2(1)], or an error message
appears [starting with Cisco NX-OS Release
7.0(3)I2(1)].
Exits control plane configuration mode.
(Optional)
Displays the CoPP configuration.
(Optional)
Copies the running configuration to the startup
configuration.
Hide quick links:
Advertisement
Table of Contents
