Table of Contents
Advertisement
Gigaset 4010 Comfort, GBR, A31008-G4010-B102-1-
Operating the handset
The display is protected by a plastic film.
Remove the protective plastic film!
Inserting the batteries
O
Insert the batteries ensuring correct polarity – see figure on left.
O
Replace cover and push gently upward until it clicks into place.
O
To open, press the grooved area on the cover and slide back.
Œ
Placing handset into base station and charging the batteries
Before activating your handset, place it in the base station with the dis-
.
play facing upward. After approx. one minute, the handset's internal
number is displayed (e.g. "INT 1"). Successful registration is signalled
by a confirmation beep (crescendo tone sequence).
Œ
Leave the handset for approx. five hours in the base station to charge
5 h
the batteries, as they are not charged in the factory. The charging sta-
tus icon flashes on the handset to indicate that the batteries are being
charged:
Note:
Your Gigaset is now ready for operation. Please set date and time (see
page 9) so that the time of incoming calls can be noted correctly.
O
Only insert the recommended rechargeable batteries (see
page 82). Never use ordinary (non-rechargeable) batteries as
they may pose a health hazard or cause injury.
O
Never use non-Siemens charging units as these may damage
the batteries.
You can register further handsets (see page 54).
Batt. flat (symbol flashes)
1
Batteries
/
charged
3
vorberei.fm
11.6.01
2
Batt.
/
charged
3
Batteries full
7
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
