About Dpvm Databases; Configuring Dpvm Config And Pending Databases; About Dpvm - Cisco MDS 9000 Series Configuration Manual
Hide thumbs
Also See for MDS 9000 Series:
- Command reference manual (1464 pages) ,
- Configuration manual (308 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Creating Dynamic VSANs
To overwrite the login information with the duplicate pWWN login, enter the dpvm overwrite-duplicate-pwwn
Note
command.
About DPVM Databases
The DPVM database consists of a series of device mapping entries. Each entry consists of a device pWWN
or nWWN assignment along with the dynamic VSAN to be assigned. You can configure a maximum of 16,000
DPVM entries in the DPVM database. This database is global to the whole switch (and fabric) and is not
maintained for each VSAN.
The DPVM feature uses three databases to accept and implement configurations.
• Configuration (config) database—All configuration changes are stored in the configuration database
• Active database—The database currently enforced by the fabric.
• Pending database—All configuration changes are stored in the DPVM pending database when distribution
Changes to the DPVM config database are not reflected in the active DPVM database until you activate the
DPVM config database. Changes to the DPVM pending database are not reflected in the config or active
DPVM database until you commit the DPVM pending database. This database structure allows you to create
multiple entries, review changes, and let the DPVM config and pending databases take effect.
Configuring DPVM Config and Pending Databases
To create and populate the DPVM config and pending databases, follow these steps:
Step 1
switch# config terminal
switch(config)#
Enters configuration mode.
Step 2
switch(config)# device-alias mode enhanced
switch(config)# device-alias commit
Enables enhanced device alias mode. This is required for device-alias configuration in the DPVM database.
Step 3
switch(config)# dpvm database
switch(config-dpvm-db)#
Creates the DPVM config database.
Step 4
switch(config)# no dpvm database
(Optional) Deletes the DPVM config database.
Step 5
switch(config-dpvm-db)# pwwn 12:33:56:78:90:12:34:56 vsan 100
Maps the specified device pWWN to VSAN 100.
when distribution is disabled.
is enabled (see the
DPVM Database Distribution, on page
26).
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
About DPVM Databases
23
Advertisement
Table of Contents
