Filtering End Devices Based On Name, Wwn Or Fc Id - Cisco MDS 9000 Series Configuration Manual
Hide thumbs
Also See for MDS 9000 Series:
- Command reference manual (1464 pages) ,
- Configuration manual (308 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Filtering End Devices Based on Name, WWN or FC ID
Step 3
Select the members you want to add from the Fabric pane (see
page
59) and click Add to Zone or click the zone where you want to add members and click the Insert icon.
You see the Add Member to Zone dialog box (see
Figure 18: Add Member to Zone Dialog Box
The Device Alias radio button is visible only if device alias is in enhanced mode. For more information, see
Note
Creating Device Aliases
Step 4
Click the browse button and select a port name or check the LUN check box and click the browse button to configure
LUNs.
Step 5
Click Add to add the member to the zone.
Note
When configuring a zone member, you can specify that a single LUN has multiple IDs depending on the
operating system. You can select from six different operating systems
Filtering End Devices Based on Name, WWN or FC ID
To filter the end devices and device aliases, follow these steps:
Step 1
Click the Zone icon in the toolbar (see
Step 2
Select Name, WWN or FC ID from the With drop-down list.
Step 3
Enter a filter condition, such as *zo1*, in the Filter text box.
Step 4
Click Go.
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
60
Figure 17: Edit Local Full Zone Database Dialog Box, on
Figure 18: Add Member to Zone Dialog Box, on page
section.
Figure 12: Zone Icon, on page
Configuring and Managing Zones
57).
60).
Advertisement
Table of Contents
