COLOR TELEVISION RECEIVER Chassis : S15A Model : CK331ET6X/BOB CK53S1TB6X/BOB CK501ETB6X/BOB CK5066TB6X/BOB CK50S1TB6X/BOB CK5366TB6X/BOB COLOR TELEVISION RECEIVER CONTENTS Precautions Specifications and IC Data Disassembly and Reassembly Alignment and Adjustment Troubleshooting Exploded View and Parts List Electrical Parts List Block Diagram...
Disassembly and reassembly 3. Disassembly and Reassembly 3-1 Back Cover Removal 1. After removing the screws, press the tension rib and pull the cabinet backwards. 2. To reassemble, press the tension rib (see diagram). Samsung Electronics...
Page 8
2. Remove the Anode Cap from the CRT. 3. Remove the main board by pulling it with both hands. Warning: The FBT is charged with high voltage. Before removing the Anode Cap, discharge the voltage through one of the heat sinks on the main board. Samsung Electronics...
Page 9
Disassembly and reassembly 3-3 Speaker Removal 1. Remove the speaker by pressing the tension rib. 1. Remove the screws. 2. Remove the speaker by pressing the tension rib. Samsung Electronics...
Page 10
Always lift the picture tube by grasping it firmly around the faceplate, (2) Never lift the tube by its neck. (3) Do not scratch the picture tube or apply excessive pressure. Fractures of the glass may cause an implosion. Samsung Electronics...
“FACTORY” or “Power OFF” keys. 3. Access the Adjustment Mode by pressing the “VOLUME” keys ( Up or Down). The adjust- ment parameters are listed in the accompany- ing table, and selected by pressing the CHAN- NEL keys ( , ). Samsung Electronics...
Page 12
0 ~ 63 STEP NTSC SUB COLOR 0 ~ 23 STEP SUB TINT 1 ~ 13 STEP TTX SUB-CONTRAST 0 ~ 63 STEP 16 (Only TTX Model) NOTE : PVS,PVA, PHS, parameters must be aligned using the 50Hz vertical-field rates. Samsung Electronics...
Page 13
L (BIT : 0) L (BIT : 0) TDA8842, CK SYSTEM, RCA JACK SYSTEM OSD DISPLAY BYTE 0 : 11 L (BIT : 1) H (BIT : 0) L (BIT : 0) H (BIT : 0) L (BIT : 1) Samsung Electronics...
Page 14
PAL : 27KHz (NTSC TABLE) Others HOTEL NOT USED MUST LOW Function Required : 1. PICTURE OFF (after 15 minutes) during no signal 4. TIMER CLOCK ON/OFF 2. AUDIO MUTE during no signal 5. No CHILD LOCK 3. BLUE SCREEN ON/OFF Samsung Electronics...
Page 15
Function Required: 1. PICTURE OFF (after 15 minutes) during no signal. 2. AUDIO MUTE during no signal. 3. No BLUE SCREEN during no RF signal (Blue Screen during AV). 4. No TIMER. 5. No CHILD LOCK. 6. See "Detailed functions of CF". Samsung Electronics...
Page 16
MILD MODE CUSTOM MODE MODE MODE 90/50/50/50 100/50/75/50 90/50/75/50 60/50/50/50 90/50/50/50 Function Required : 1. PICTURE OFF (after 15 minutes) during no signal 4. TIMER available 2. AUDIO MUTE during no signal No CHILD LOCK SCREEN available 3. BLUE Samsung Electronics...
Page 17
PAL : 27 KHz (NTSC TABLE) Others GAME MUST = LOW Function Required : 1. PICTURE OFF (after 15 minutes) during no signal 2. AUDIO MUTE during no signal. SCREEN ON/OFF 3. BLUE 4. TIMER (CLOCK ON/OFF) CHILD LOCK ON (always) Samsung Electronics...
Page 18
Function Required : 1. PICTURE OFF (after 15 minutes) during no signal. 2. AUDIO MUTE during no signal. BLUE SCREEN ON/OFF. 4. TIMER (CLOCK ON/OFF). 5. No CHILD LOCK → SZM -173ET (16K) : Z90203 WITHOUT LINE STEREO → SZM -173EV (24K) : Z90234 WITH LINE STEREO Samsung Electronics...
Page 19
2. Arab (Middle East, Africa) : SPM-175EA : English/French/Arabian Function Required : 1. PICTURE OFF (after 15 minutes) during no signal 4. No TIMER 2. AUDIO MUTE (during no signal) 5. No CHILD LOCK 3. No BLUE SCREEN Samsung Electronics...
Page 20
CUSTOM MODE 90/50/50/50 100/50/50/50 75/55/50/50 60/50/50/50 90/55/25/50 Function Required :1. PICTURE OFF (after 15 minutes) during no signal. 2. AUDIO MUTE (during no signal). 3. No BLUE SCREEN. 4. No TIMER (CLOCK /OFF). 5. No CHILD LOCK 4-10 Samsung Electronics...
Page 22
Alignment and Adjustments 4-2-4 (I) DIFFERENCE WHEN APPLYING PHILIPS PAINT MICOM 4-12 Samsung Electronics...
Page 23
Alignment and Adjustments 4-2-4 (J) DIFFERENCE WHEN APPLYING PHILIPS PAINT MICOM Samsung Electronics 4-13...
Page 24
Alignment and Adjustments 4-2-4 (K) DIFFERENCE WHEN APPLYING PHILIPS PAINT MICOM 4-14 Samsung Electronics...
Page 25
Alignment and Adjustments 4-2-4 (L) 915C VS 915E PCB DIFFERENCE LIST Samsung Electronics 4-15...
Page 26
Alignment and Adjustments 4-2-4 (M) 915C VS 915E PCB DIFFERENCE LIST 4-16 Samsung Electronics...
Page 27
Alignment and Adjustments 4-2-4 (N) 915C VS 915E PCB DIFFERENCE LIST Samsung Electronics 4-17...
Page 28
Alignment and Adjustments 4-2-4 (O) 915C VS 915E PCB DIFFERENCE LIST 4-18 Samsung Electronics...
Page 29
7. Do not attempt to connect or disconnect any wires while the TV is turned on. Make sure that the power cord is disconnected before replacing any parts. 8. To protect against shock hazard, use an isola- tion transformer. Samsung Electronics Samsung Electronics...
Page 30
STANDARD picture. 4. Adjust the Screen VR (on the FBT) so that the voltage on the oscilloscope becomes 130+2.5V (See Fig. 4-1). 130 2.5V 14, 16" :120 2.5V 20, 21" : 130 2.5V Fig. 4-1 Samsung Electronics Samsung Electronics...
Page 31
2. Adjust RG,BG so that the levels are suitable to each local area. (c) High-Light Adjustment 1. Set SCT to 55 FL (20”. 21”), 65 FL(14”.16”) in the Factory Service Mode with using CA100. See Fig. 4-4 Samsung Electronics Samsung Electronics...
Page 32
6-Pole Magnet Movement 4-Pole Magnet Movement Fig. 4-5 Center Convergence Adjustment 4-3-9 VCO Adjustment Set the vco data to 80 (Factory Mode). NOTE : For SZM-173EW and SPM-175E (Western Europe remote control), set the VCO data to 1. Samsung Electronics Samsung Electronics...
Page 33
4. Fig. 4-7 4. Adjust with PSL (Vertical-Slope) so that the bottom margin of the picture is 4. Fig. 4-8 5. Adjust with PHS (Horizontal Shift) so that the lion-head pattern and CRT centers are aligned. Samsung Electronics Samsung Electronics...
5-1 No Video (Raster On, No Sound) Open the IF Pin of Tuner Measure the Check/Replace Voltage of Each Pin TU01, of TU01 Check IC901 Check/Replace Pins 39, 40 IC901, IC201 See "No Sound" See "No Video" (Video OK) (Sound OK) Samsung Electronics...
SOUND L IN SOUND L OUT SOUND R IN SOUND R OUT CN602 FRONT VIDEO IN L + OUT L - OUT 21 PIN VIDEO IN R - OUT R + OUT 21 PIN AUDIO IN FRONT AUDIO OUT Samsung Electronics...
? @ e ? @ ) X g @ ? ? @ e ? @ @ TP05 TP06 TP10 TP01 TP07 TP08 TP08 TP07 TP11 TP09 TP10 TP09 TP06 TP11 TP12 : Power Line : Signal Line Samsung Electronics 10-1...
Page 56
PRODUCT SAFETY NOT CE S gna L ne n manua Do no d g ad y o h h ough mp op v ng 10-4 Samsung Electronics...
Page 57
@ ? e @ ? h f @ @ e ? @ @ ? @ ? e @ ? h f @ @ e ? @ @ ? TP02 TP01 TP03 Powe L ne S gna L ne Samsung Electronics 10-5...
Page 58
@ @ L ? V 4 @ @ e V 4 @ @ 0 Y e @ @ f @ @ ? @ @ ? ? @ @ ? ? @ @ ? @ @ ? @ @ @ @ @ @ ? V 4 @ @ @ H ? V 4 @ @ 0 Y ? @ @ ? V 4 ) ? V 4 @ @ @ 0 Y e 7 @ H ? e ? V 4 @ @ 0 Y ? h e @ ? ? I / ? ? I @ ? TP03 TP02 TP01 Powe L ne S gna L ne 10-6 Samsung Electronics...
Page 59
@ @ L ? V 4 @ @ e V 4 @ @ 0 Y e @ @ f @ @ ? @ @ ? ? @ @ ? ? @ @ ? @ @ ? @ @ @ @ @ @ ? V 4 @ @ @ H ? V 4 @ @ 0 Y ? @ @ ? V 4 ) ? V 4 @ @ @ 0 Y e 7 @ H ? e ? V 4 @ @ 0 Y ? h e @ ? ? I / ? ? I @ ? TP03 TP02 TP01 Powe L ne S gna L ne Samsung Electronics 10-7...
Page 60
? @ e ? @ ) X g @ ? ? @ e ? @ @ ) X ? f @ ? TP05 TP06 TP10 TP01 TP07 TP08 TP06 TP07 TP08 TP11 TP09 TP10 TP09 TP11 TP12 Powe L ne S gna L ne 10-8 Samsung Electronics...
Page 63
: Signal Line p a ng h ompon n ad a u y h PRODUCT SAFETY NOT CE n manua Do no d g ad y o h h ough mp op v ng Samsung Electronics 10-11...
Page 64
@ ? e @ ? h f @ @ e ? @ @ ? @ ? e @ ? h f @ @ e ? @ @ ? TP02 TP01 TP03 : Power Line : Signal Line 10-12 Samsung Electronics...
Page 65
@ @ L ? V 4 @ @ e V 4 @ @ 0 Y e @ @ f @ @ ? @ @ ? ? @ @ ? ? @ @ ? @ @ ? @ @ @ @ @ @ ? V 4 @ @ @ H ? V 4 @ @ 0 Y ? @ @ ? V 4 ) ? V 4 @ @ @ 0 Y e 7 @ H ? e ? V 4 @ @ 0 Y ? h e @ ? ? I / ? ? I @ TP03 TP02 TP01 : Power Line : Signal Line Samsung Electronics 10-13...