Page 2
Dolby* B-type noise reduction system. * Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories. The TC-TX595 tape deck is designed for the stereo systems listed below • DHC-MD313 • DHC-MD333 • DHC-MD373 •...
Timer You can wake up to music or record a radio programme at a preset time. For details, refer to “Waking up to music” and “Timer recording radio programmes” in the stereo system operating instructions. Remote Control If the remote supplied with the stereo system has buttons with the same names as the controls on the tape deck, you can also operate the tape deck using these buttons.
The stereo systems with the tape control jack (DHC-MD373/595) Complete steps 1 to 3, 5 to 7 below to hook up your system using the supplied cords. Audio connecting cords (supplied) TC-TX595 rear panel Mains lead AU BUS connecting cable...
Page 5
Connection to the DHC- MD373/595 Firmly connect the AU BUS connecting cable to the system cable adapter. TC-TX595 AU BUS connecting cable Peel away the seal paper from the back of the system cable adapter and secure the adapter to the DHC-MD373/595.
Page 6
AU BUS connecting cable firmly, the tape deck and DHC-MD373/595 may not operate correctly. Connection to the DHC- MD313/333 TC-TX595 DHC-MD333 DHC-MD373 Note The AU BUS connecting cable is used for exchanging signals between the tape deck and the DHC-MD313/ 333.
Page 7
Insert the plugs into jacks of the same colour. The two audio connecting cords are the same, so you can connect A or B using either cord. TC-TX595 rear panel TAPE DHC-MD373 rear panel TC-TX595 rear panel TAPE...
TYPE II (CrO ) or TYPE IV (metal), since the tape deck automatically detects the tape type (ATS ATS: Automatic Tape Selection. Tape deck TC-TX595 DOLBY NR Cassette indicator This tape deck is equipped with the Dolby B-type noise reduction system.
Other operations Do this Press x. Stop playing Press S. Pause Press again to resume playing. Press x, then M for the top Fast-forward side. Press x, then m for the bottom side. Press x, then m for the top Rewind side.
You can use TYPE I (normal) or TYPE II (CrO ) tape, since the tape deck automatically detects the tape type. Tape deck TC-TX595 DOLBY NR* Cassette indicator * This tape deck is equipped with the Dolby B-type noise reduction system.
CD, or start recording from the middle of the tape. You can also record a radio programme or MD. Tape deck TC-TX595 DOLBY NR* * This tape deck is equipped with the Dolby B-type noise reduction system.
Recording manually (continued) Switch the function of the stereo system to the desired sound source (e.g. “CD,” “MD,” “AM”or “FM”). Set DIRECTION to g to record on one side. Set it to s to record on both sides. Press zREC on the tape deck. The tape deck stands by for recording.
Use a soft cloth slightly moistened with mild detergent solution. Never use strong solvents, such as thinner or benzene, since they may damage the finish. If you have any questions or problems concerning your tape deck, please consult your nearest Sony dealer.
First, check that the mains lead is connected firmly and the speakers are connected correctly and firmly. Should any problem persist, consult your nearest Sony dealer. The operation buttons on the tape deck do not work. • Press any of the operation buttons after S stops flashing.
Recording system 4-track 2-channel stereo Frequency response (DOLBY NR OFF) 50 – 14,000 Hz (±3 dB), using Sony TYPE I cassettes 50 – 15,000 Hz (±3 dB), using Sony TYPE II cassettes Wow and flutter ±0.13% W. Peak (IEC) 0.07% W. RMS (NAB) ±0.2% W.