Table of Contents
Advertisement
Chapter 2
Command-Line Interface
Table 2-1
Level
Admin
Root
CLI Command Mode Hierarchy
The set of all CLI commands is grouped in hierarchical order, according to the type of the commands.
The first two levels in the hierarchy are the User Exec and Privileged Exec modes. These are
non-configuration modes in which the set of available commands enables the monitoring of the Cisco
SCE platform, file system operations, and other operations that cannot alter the configuration of the
Cisco SCE platform.
The next levels in the hierarchy are the Global and Interface configuration modes, which hold a set of
commands that control the global configuration of the Cisco SCE platform and its interfaces. Any of the
parameters set by the commands in these modes should be saved in the startup configuration, such that
in the case of a reboot, the Cisco SCE platform restores the saved configuration.
Table 2-2
Table 2-2
CLI Modes
Mode
Description
User Exec
Initial mode. Also allows monitoring of the system
(show commands).
Privileged Exec
General administration; file system manipulations
and control of basic parameters that do not change
the configuration of the Cisco SCE platform.
Global Configuration
Configuration of general system parameters, such
as DNS, host name, and time zone.
Management Interface
Configuration of management interface
Configuration
parameters, such as the Ethernet interface
properties and selection of the active port.
Interface
Configuration of specific system interface
Configuration
parameters, for the following interface modes.
•
•
Interface Range
Configuration of a range of traffic interfaces.
Configuration
Line Configuration
Configuration of Telnet lines, such as an
access-list.
OL-30621-02
Authorization Levels (continued)
Description
Password required. For use by general administrators, the
Admin authorization level enables configuration and
management of the Cisco SCE platform.
Password required. For use by technical field engineers,
the Root authorization level enables configuration of all
advanced settings, such as debug and disaster recovery.
The Root level is used by technical engineers only.
shows the available CLI modes.
linecard interface
specific traffic interface
Authorization and Command Mode Levels (Hierarchy)
Level
Prompt indication
User/Viewer
SCE>
•
Admin
•
SCE#
•
SCE#>
Root
•
•
Admin
•
SCE(config)#
•
SCE(config)#>
Root
•
•
Admin
•
SCE(config if)#
•
SCE(config if)#>
Root
•
•
Admin
•
SCE(config if)#
•
SCE(config if)#>
Root
•
•
Admin
•
SCE(config if range)#
•
SCE(config if range)#>
Root
•
•
•
Admin
SCE(config-line)#
•
SCE(config-line)#>
•
Root
Cisco SCE 8000 10GBE Software Configuration Guide
Value
Prompt
10
#
15
#>
2-3
Advertisement
Chapters
Table of Contents
