Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Linksys Velop Plug-in WHW01P
Summary of Contents for Linksys Velop Plug-in WHW01P
- Page 1 User Guide Velop Plug-in...
-
Page 2: Table Of Contents
A Velop Plug-in requires an existing Velop system __________________________________________________ 6 Set Up _________________________________________________________________________________________________________ 7 How to restore factory defaults __________________________________________________________________________ 8 Velop System Settings ______________________________________________________________________________________ 8 Where to find more help ____________________________________________________________________________________ 9 Specifications ______________________________________________________________________________________________ 10 Linksys Velop Plug-in ______________________________________________________________________________________ 10 Environmental ______________________________________________________________________________________________ 10... -
Page 3: Product Overview
Status Blue (blinking) Starting up Wait for the node to finish starting up. Ready for setup Purple Open the Linksys app to complete setup. Purple (binking) Setup in progress Follow instructions in the app. Blue Connected to internet Node is online, everything is good. -
Page 4: Side/Back
Side/Back Reset button—Press and hold until the light on front of the node turns red, fades and flashes bright red again to reset the node to its factory defaults. - Page 5 Network of nodes Every home is unique. Velop creates a modular mesh system of Wi-Fi nodes to provide wireless coverage throughout your home. Whether you have one node, three nodes, or more, we'll help you get them in the right spot - one at a time - for the best performance everywhere. Velop Plug-in must be used with an existing Velop system and requires a Velop primary node connected to your modem with an ethernet cable.
-
Page 6: A Velop Plug-In Requires An Existing Velop System
A Velop Plug-in requires an existing Velop system Be sure your primary node is already set up before adding a plug-in. -
Page 7: Set Up
Set Up 1. Open the Linksys app. 2. Log in 3. Find and tap "Set up a New Product" in the main menu. 4. Select "Add Another Node" and follow setup instructions. -
Page 8: How To Restore Factory Defaults
You can access settings from anywhere in the world if you have an internet connection, but you can also access your Velop system directly from your home network if you are not online. To view the Velop user guide, detailing how to use the Linksys app go to linksys.com/support/Velop. -
Page 9: Where To Find More Help
Where to find more help Linksys.com/support/Velop • • Linksys app help (launch the app and click Help in the main navigation menu) Note—Licenses and notices for third party software used in this product may be viewed on http://support.linksys.com/en-us/license. Please contact http://support.linksys.com/en- us/gplcodecenter for questions or GPL source code requests. -
Page 10: Specifications
Storage Humidity 5% to 90% non-condensing Notes: For regulatory, warranty, and safety information, go to Linksys.com/support/Velop. Specifications are subject to change without notice. Maximum performance derived from IEEE Standard 802.11 specifications. Actual performance can vary, including lower wireless network capacity, data throughput rate, range and coverage. - Page 11 Visit linksys.com/support/Velop for award-winning technical support. BELKIN, LINKSYS and many product names and logos are trademarks of the Belkin group of companies. Third-party trademarks mentioned are the property of their respective owners. © 2018 Belkin International, Inc. and/or its affiliates. All rights reserved.