Maintenance; Greasing The Trencher; Servicing The Trencher Digging Chain - Toro RT600 Operator's Manual
Direct drive trencher
Hide thumbs
Also See for RT600:
- Operator's manual (44 pages) ,
- Installation instructions (4 pages) ,
- Operator's manual (72 pages)
Table of Contents
Advertisement
Maintenance
Greasing the Trencher
Service Interval: Every 50 hours
1. Clean the grease fittings with a rag.
2. Connect the grease gun to the grease fitting for the
bearing of the lower lift cylinder, and apply 3 pumps of
grease to the fittings
30).
3. Wipe up any excess grease.
Figure 28
Figure 29
(Figure
28,
Figure
29, and
Figure
Servicing the Trencher Digging
Chain
Checking the Chain Tension
Service Interval: After the first 10 hours
Before each use or daily
1. Start the engine.
2. Make a trench about 3 m (10 ft) long.
3. Stop the trencher chain and lift the boom out of the
trench.
4. Move the boom to the horizontal position
1. Lower wear strip
2. 51 to 76 mm (2 to 3 inch)
gap
5. Shut off the engine and remove the key.
18
Figure 30
(Figure
Figure 31
3. Chain
31).
Hide quick links:
Advertisement
Table of Contents
