JVC BR-EN900 Quick Setup Manual

Hide thumbs Also See for BR-EN900:

Download this manual

• Configure IP address, Default Gateway and DNS servers

• Confirm that Use as Primary Default Gateway is "checked" for the LAN port in use.

Select Input

• Click Apply to save settings

Configure channels

Save Configuration

Select Auto Start

The BR-EN900 features two encoding channels – HEVC and H.264, each with a separate IP destination.

Input must be selected in the HEVC channel settings, the H.264 channel will follow HEVC selection.

Both channels encode video from the same input but can

stream to different destinations / IP addresses.

SDI

HDMI

DVI-D

Remember to click Apply after any change.

Save existing configuration and select Auto Start

to apply all settings after power OFF/ON

The BR-EN900 Quick Setup Guide

• Set PC IP address to 192.168.1.xxx

• Connect to the Ethernet 1 port

• Enter 192.168.1.3 in the browser

• Default password – jvc1234

192.168.1.3

H.264

Protocols:

• UDP TS

• RTP TS

HEVC

• Pro-MPEG (RTP+SMPTE2022 FEC)

• Zixi

• RTP ES (RTSP pull)

• UDP TS

• RTP TS

• Pro-MPEG (RTP+SMPTE2022 FEC)

• Zixi

• RTMP (CDN)

Page 1 Save Configuration Select Auto Start The BR-EN900 features two encoding channels – HEVC and H.264, each with a separate IP destination. Input must be selected in the HEVC channel settings, the H.264 channel will follow HEVC selection. Both channels encode video from the same input but can Protocols: stream to different destinations / IP addresses.
Page 2 The BR-EN900 encoding (HEVC and H.264) Start/Stop is controlled in the Actions section of the GUI. Start / Stop encoding In order to make any changes to encoding parameters, each channel must be stopped and restarted after changes are applied. To automatically start encoding upon power ON, save Configuration and enable the Auto Start. Configuration captures the current status of the encoder with all associated settings, so channels must be running prior to saving the Configuration.