Table of Contents
Advertisement
Controls System
Maintenance
Adjusting the Traction
Control
If the traction control does not engage or if it slips
during operation, an adjustment is necessary.
1.
Move the traction control to the E
position.
2.
Measure the distance from the pin on either
end of the traction-control spring
it is not within 7.3 to 7.6 cm (2-7/8 to 3 inches),
adjust the clutch according to the steps below.
Figure 48
1. Measure this distance
(should be 7.3 to 7.6 cm
(2-7/8 to 3 inches).
2. Traction-control spring
3. Clevis pin
A.
Disengage the traction-control lever.
B.
Loosen the jam nut on the turnbuckle and
remove the clevis pin, disconnecting the
spring from the turnbuckle
C.
Turn the turnbuckle in or out to adjust the
length as necessary.
D.
Install the turnbuckle to the spring with the
clevis pin.
NGAGED
(Figure
48); if
g032417
4. Turnbuckle
5. Jam nut
(Figure
48).
E.
Move the traction control to the E
position.
F.
Measure the distance from the pin on either
end of the traction-control spring
48); repeat steps
within 7.3 to 7.6 cm (2-7/8 to 3 inches).
Adjusting the Reel Control
If the reel control does not properly engage, an
adjustment is necessary.
1.
Ensure that the reel control is disengaged.
2.
At the transmission bulkhead, adjust the
reel-control cable
length of 70.6 to 72.4 mm (2.78 to 2.85 inches).
1. Reel-control cable
3.
At the control-handle bulkhead, loosen the
reel-control cable until there is slack in the cable
(Figure
50).
36
NGAGED
(Figure
A
through
F
until it is
(Figure
49) to attain a spring
Figure 49
2. Jam nuts
g017020
Advertisement
Table of Contents
