Page 1
HDCAM INPUT BOARD BKMA-720 INSTALLATION MANUAL 1st Edition Serial No. 10001 and Higher...
Page 2
Ce manual est destiné uniquement aux personnes compétentes en charge de l’entretien. Afin de réduire les risques de décharge électrique, d’incendie ou de blessure n’effectuer que les réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres. Pour toute réparation faire appel à une personne compétente uniquement. BKMA-720...
In the Case of 2-IN and 2-OUT ..........1-2 (E) 1-2-2. In the Case of 3-IN and 1-OUT ..........1-5 (E) 2. Service Overview 2-1. Description of Internal Switches and Indicators ........2-1 (E) 2-1-1. ENC-72 Board ..............2-1 (E) 2-2. Specifications ..................2-3 (E) 1 (E) BKMA-720...
The following is a summary of all the section for understanding the contents of this manual. Section 1 Installation Explains the overview of the BKMA-720, how to install the BKMA-720 to the MAV-777. Section 2 Service Overview Explains the internal switches and indicators, specifications of the BKMA-720.
Installation 1-1. Overview The HDCAM input board BKMA-720 can expand the number of input and output ports of the multi- access video disk recorder MAV-777 to 3-IN and 1-OUT by installing the 2 pieces of the BKMA-720. When one piece of the BKMA-730 and another piece of the BKMA-720 are installed, the number of input and output ports of the multi-access video disk recorder MAV-777 can be expanded to 2-IN and 2- OUT.
Harness Cover 1-2-1. In the Case of 2-IN and 2-OUT Tie band Add one piece of the BKMA-720 board (ENC-72 board) and one piece of the BKMA-730 board (DEC-136 board) respectively. 1. Turn off the power of the MAV-777. 2. Loosen the two screws (with drop-safe), and remove Bend the top panel.
Page 9
10. Insert the ENC-72 board in the slot No. 5. two harnesses that are supplied with the BKMA-720, 11. Connect the four harnesses as shown in the following to the EM-4 board and to the DEC-136 board in the table among the harnesses that are removed in step 4, slot No.
Page 10
DEC-136 board in two harnesses that are supplied with the BKMA-720, the slot No. 6. When securing the harnesses, fix the to the EM-4 board and to the ENC-72 board in the slot center wire clamp in the direction shown by the No.
1-2-2. In the Case of 3-IN and 1-OUT Slot No. 6 Board levers Add the two BKMA-720 boards (ENC-72 boards). 1. Insert the ENC-72 board in the slots No. 5 and No. 6 referring to steps 1 to 6 of 1-2-1. “In the Case of 2-IN and 2-OUT”.
Page 12
(one clamp) on the EM-4 board in the slot No. 10. Slot No. 5 Slot No. 10 (ENC-72 board) (EM-4 board) Wire clamp Slot No. 6 (DEC-136 board) Black Black 1-6 (E) BKMA-720...
Page 13
(4) Secure the harnesses coming from the EM-4 board with the two wire clamps on the ENC-72 board in the slot No. 5. Slot No. 5 (ENC-72 board) Slot No. 10 (EM-4 board) Wire clamp Wire clamp Black 1-7 (E) BKMA-720...
1 2 3 4 5 6 7 8 Use this switch in the factory setting (see below.). S1301-1 to 4 : ON S1301-5 to 7 : OFF S1301-8 : ON (Enable of the EPR connector) S1801 (J-1) Reset switch Initializes the ENC-72 board. 2-1 (E) BKMA-720...
Page 16
D1003 (F-3) Green For test Turns off D1004 (F-3) Green For test Turns off D1601 (B-1) Green INIT_DONE IC1401 configuration error display Turns on Turns on : Configuration ends normally Turns off : Configuration error occurs 2-2 (E) BKMA-720...
2-2. Specifications 2-2. Specifications BKMA-720 General +5 dC to +40 dC Operating temperature Storage temperature _20 dC to +60 dC Operating humidity 25% to 80% 294 x 20 x 222.6 (w/d/h) (not including protrusions) External dimensions inches) Mass Approx. 0.5 kg (1 lb 1...
Page 19
The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any...