Table of Contents
Advertisement
Defining Hardware
In the Siemens PG 720 Hardware Control submenu, you can define the
(Page 2 of 3)
interface functions. These values must be re-entered particularly when you
have re-assigned interfaces or when you want to connect I/O devices (for
example an external monitor).
Figure 6-2
Siemens PG 720 Hardware Control Submenu
Caution
!
Risk of damaging the monitor!
If you are using a monitor with a higher resolution, switch CRT/LCD
selection to "CRT enabled" in the SETUP program. The higher resolution
must be set on the monitor you are using.
Setting a resolution that is too high in the SETUP program can damage the
monitor.
PG 720 Programming Device
C79000-G7076-C720-02
Phoenix SETUP Utility (Version X.XX)
(c) Phoenix Technologies Ltd. 1985, 1994
** Siemens PG 720 Hardware - Control **
MPI Adr.-Range:
Adr.- CC00H
PCMCIA Slot:
Enabled
Programming Interf.:
Enabled
Internal COM1:
COM1 03F8h
Internal COM2:
COM2 02F8h
Internal LPT1:
UNI-Directional
CRT / LCD selection:
SIMULTANEOUS
CRT 800 x 600:
72 Hz
CRT 1024 x 768:
Non Interlaced
LCD - Screensize:
Expanded
Configuring the Programming Device
All Rights Reserved
Page 2 of 3
Backlight:
Full on
Internal Mouse:
Internal
4
3
6
6-5
- Quick Links:
- Hardware Components of the
Hide quick links:
Advertisement
Table of Contents
