Table of Contents
Advertisement
Installing and Operating the PG 760 PII
3.1
Connecting the PG 760 PII to the Power Supply
Connecting to the
The PG 760 PII can be operated at 120 V or 240 V. Voltage selection is
Power Supply
carried out via the mains voltage selector.
Caution
!
Risk of damage to the unit!
Operating the PG 760 PII with the incorrect mains voltage can damage the
unit. When switched on, the same voltage is present on the appliance socket
(outlet) as on the appliance plug (mains inlet). To operate the monitor, please
observe the manufacturer's specifications. Only a monitor with the following
rated currents may be connected to the appliance socket:
Selecting Mains
If the voltage displayed on the system selector switch does not correspond
Voltage
with your local voltage, you must move the mains voltage selector so that the
voltage set next to the white triangle is visible.
To do this, use a small, flat screwdriver to lever out the part with the voltages
printed on it and replace it in the appropriate position.
Figure 3-1
3-2
120 V
3 A max.
240 V
1.5 A max.
Appliance socket
(outlet)
Appliance socket
(inlet)
Mains voltage
selector
On/Off switch
Mains Voltage Selector
Mains
voltage
selector
PG 760 PII Programming Device
C79000-G7076-C766-01
Advertisement
Table of Contents
