Advertisement
Quick Links
Advertisement
Related Manuals for Epson C831
Summary of Contents for Epson C831
- Page 1 USER MANUAL Longitudinal Label Slitter for EPSON C831 this product is certified...
-
Page 2: Installation
INSTALLATION STEP 1 Assemble the printer plate. STEP 2 Connect the slitter to the printer plate. Label Unwinder (optional) STEP 3 Load the cardboard cores onto the core holder. STEP 4 Place the core holder in position. The grey handle must match with the grey holder. - Page 3 Paper Path Label face out Label face in Finished roll from Waste printer STEP 5 Attach the labels to the cores. This will provide the necessary tension in order start the slitting process. STEP 6 Align the blades with the edges and the center of the labels, tighten the thumb screw once the blade is in position.
- Page 4 OPEN CLOSE Slitter module has 3 positions: - Upper position (A), the blades are closed to allow the media loading; - Middle position (B), align the blades with the edges and the center of the labels, tighten the thumb screw once the blade is in position; - Lower position (C), the blade cut the media.
- Page 5 STEP 7 Switch on the Slitter. Slowly turn the speed knob. Run the slitter until the labels reach the bottom of the take-up core holder. Remove the labels that have rewinded onto the take-up core holder. STEP 8 Attach the labels to the core using a waste label or tape.
- Page 6 REWINDER GUIDES ALIGNMENT Metal glides adjustable to obtain rolls of labels perfectly aligned. ULTRASONIC SENSOR CALIBRATION WARNING: Before proceeding with the ultrasonic sensor calibration, turn “OFF” the module that needs to be calibrated (laminating or matrix removing). 1. Take a paper clip and insert it into the little hole located next to the OFF-ON switch and push it down for 5 seconds.
- Page 7 LAMINATION / MATRIX REMOVER & SLITTER MODULES SPEED ROTATION MATRIX REMOVER & SLITTER MODULE ULTRASONIC TENSION CONTROLLER WARNING: If what (pictured above) is not happening, please press the button on circuit board untill the yellow led flashes. After it flashes for 5 times release the button and perform a new test.
- Page 8 smart solutions for the labeling industry Label rewinder, label unwinder, electronic label dispenser and more... - FOR MORE INFO CONTACT YOUR RESELLER -...