Troubleshooting - Husqvarna 553RBX Operating Instructions Manual
Hide thumbs
Also See for 553RBX:
- Operator's manual (206 pages) ,
- Workshop manual (72 pages) ,
- Operator's manual (284 pages)
Table of Contents
Advertisement
Available languages
Available languages
3. Push and turn the drive shaft at the same time to put
it back in the drive shaft sleeve. Keep approximately
10 mm / 0.40 in. of the drive shaft outside the edge
of the drive shaft sleeve.
The engine does not start
Check
Stop switch.
Starter pawls.
Fuel tank.
Spark plug.
The engine starts but stops again
Check
Fuel tank
24
Troubleshooting
Possible cause
The stop switch is in the stop posi-
tion.
The starter pawls cannot move free-
ly.
Incorrect fuel type.
The spark plug is dirty or wet.
The spark plug electrode gap is in-
correct.
The spark plug is loose.
Possible cause
Incorrect fuel type.
4. Align the hole in the drive shaft sleeve with the knob
on the clutch cover.
5. Push and turn the drive shaft at the same time to
connect it.
Procedure
Let an approved service agent re-
place the stop switch.
Remove the starter cover and clean
around the starter pawls. See
uct overview on page 2 .
Let an approved service agent help
you.
Drain the fuel tank and fill with cor-
rect fuel.
Make sure that the spark plug is dry
and clean.
Clean the spark plug. Make sure that
the electrode gap is correct. Make
sure that the spark plug has a su-
pressor.
Refer to technical data for correct
electrode gap.
Tighten the spark plug.
Procedure
Empty the fuel tank and fill it with correct fuel.
Prod-
1104 - 001 - 11.04.2019
- Quick Links:
- Assembly
- Operation
- Maintenance
- Technical Data
Hide quick links:
Advertisement
Chapters
Table of Contents
