Table of Contents
Advertisement
Configuring the WLSE's Network Information
Configuring the WLSE's Network Information
Guidelines for Using the Setup Program
Running the Setup Program
Step 1
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
3-2
Use the setup program to configure the WLSE when you boot it for the first time,
and after erasing the configuration.
When using the setup program:
Press the Backspace or Delete key to delete characters when entering a
•
response to a prompt.
You cannot edit a response after you press the Enter key. You can use CLI
•
commands to change some responses after running setup; see
Configuration After Running Setup, page
You can exit the setup program in two ways:
•
Press Ctrl-c.
–
The login prompt appears. Log in as the user setup to rerun the setup
program.
Enter no at the final prompt:
–
Would you like to save this configuration? [yes].
The setup program exits without saving the configuration, then restarts.
See
Table 3-2 on page 3-3
enter into the setup prompts.
To configure WLSE network information, perform the following steps:
Connect a console terminal or PC to the serial/console port on the back panel. Do
not use the video port for this purpose.
3-5.
and
Table 3-3 on page 3-4
Chapter 3
Setting Up the WLSE
Changing the
for the data you will need to
78-16778-01
Advertisement
Table of Contents
