Table of Contents
Advertisement
Discovering Devices
Step 8
Modify the CDP Discovery Schedule
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
5-10
If the summary is not correct, click Back to make changes in any of your settings.
A popup message displays the name of the discovery and the Discovery Run
Details window appears. Click Refresh to update the Job Run Log.
To modify the default discovery schedule, perform the following steps:
Select Devices > Discover > Discover > Discovery Wizard.
Select Automatic Device Discovery based on Cisco Discovery Protocol, and
click Next.
Select Modify Periodic and click Next.
To modify the schedule:
Select the Start Date and Start Time from the pull-down lists.
a.
To repeat discovery at a specified interval, select Enable. Then enter a
b.
number for the interval and select Minutes, Hours, Days, Weeks or Months
from the pull-down list.
Click Next.
c.
If you already added community strings, click Next.
If you have not added community strings, you must add them now. For details on
adding community strings, see
Devices, page
5-3. After adding community strings, click Next.
Add one or more initiating IP addresses (seeds):
If CDP is not enabled, you still can discover devices by entering each of
Note
their IP addresses as seeds in this window, however the connectivity
between switches and access points will not be discovered.
Enter the IP addresses or device names in the Add Seed Values text box and
a.
click >>.
Chapter 5
Setting Up Discovery and Device Management
Enter SNMP Community Strings for All Managed
78-16778-01
Advertisement
Table of Contents
