Reversing The Cable Management Arm (Optional); Initial Server Setup - Cisco UCS C Series Installing Manual
Hide thumbs
Also See for UCS C Series:
- Programmer's manual (138 pages) ,
- Configuration manual (88 pages) ,
- Installing (20 pages)
Table of Contents
Advertisement
Reversing the Cable Management Arm (Optional)
Step 5
Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides as desired.
Reversing the Cable Management Arm (Optional)
Step 1
Rotate the entire CMA assembly 180 degrees, left-to-right. The plastic cable guides must remain pointing upward.
Step 2
Flip the tabs at the ends of the CMA arms so that they point toward the rear of the server.
Step 3
Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the outside of the tab
and pivot the tab 180 degrees so that it points toward the rear of the server.
Figure 6: Reversing the CMA
1
CMA tab on end of width-adjustment slider
Initial Server Setup
Note
This section describes how to power on the server, assign an IP address, and connect to server management
when using the server in standalone mode. To use the server in Cisco UCS Manager integration, specific
cabling and settings are required. See
Installing the Server
10
2
Metal button on outside of tab
Installation For Cisco UCS Manager
Installing the Server
Integration.
Advertisement
Table of Contents
