Advertisement
2. Install the outrigger with the nuts (A) and (B).
C
A
D
B
Introduction
WARNING Read and understand the safety
chapter before you use the product.
To do before you operate the product
WARNING Do not touch the shaft during
operation of the product. The shaft rotates
and can cause serious injury.
•
Read the operator's manual carefully and make sure
that you understand the instructions.
•
Read the engine manual that is supplied by the
engine manufacturer.
•
Do the daily maintenance. Refer to
maintenance on page 12 .
•
Make sure that there are no objects near the product
that can get caught in the shaft during operation.
•
Make sure that the bottom edge of the product is
straight. Adjust with the stretching screws as
necessary and make sure that the locknuts are fully
tightened.
•
Make sure that the direction of rotation of the shaft is
correct for the operation.
•
Make sure that the rails are stable. Rails that are not
stable can cause the product to tilt or prevent correct
movement of the product.
1499 - 001 -
3. Adjust the outrigger with the nuts (C) and (D).
Operation
To make the bottom edge of the
product straight
1. When the product is assembled, put the ends on
2. Attach a string (A) along the bottom edge of the
3. Apply tension to the string to make it straight.
4. Loosen the locknuts (B).
To do daily
5. Adjust the tension at each joint with the stretching
6. Tighten the locknuts (B).
7. Look at the bottom edge of the product and the
Direction of rotation
You get the best results if the shaft rotates in the
opposite direction of the operation direction. The tension
trestles to free the bottom edge of the product.
product.
A
screw (C) until the full length of the product is
straight.
string to make sure that the product is straight.
B
C
9
Advertisement
