Download Print this page

Installing And Removing Sfp Modules - Cisco IE 3010 Installation Instructions Manual

Hide thumbs Also See for IE 3010:

Table of Contents

Switch Installation

Installing and Removing SFP Modules

Figure 24

Wall-Mounting the Cisco IE-3010-16S-8PC

After the switch is mounted on the wall:



Wire the switch to a power source. See



For configuration instructions about using the CLI setup program, go to

Program, page 81



Connect the switch ports. See the

Installing and Removing SFP Modules

This section presents procedures to install and remove fiber-optic and 1000BASE-T SFP transceiver modules.

Installing SFP Modules

These sections describe how to install and remove SFP modules. SFP modules are inserted into SFP module slots on the

front of the switch. Field-replaceable SFP modules provide the uplink interfaces, send (TX) and receive (RX).

You can use any combination of rugged SFP modules. See

module must be of the same type as the SFP module on the other end of the cable, and the cable must not exceed the

stipulated cable length for reliable communications. See

connections.

Power Supply Installation, page 47

Connecting Devices to the Ethernet Ports, page

Table 2 on page 8

Table 20 on page 74

Configuring the Switch with the CLI Setup

44.

for a list of supported modules. Each SFP

for cable stipulations for SFP module

Table of Contents