Attach The Optical Network Cable - Cisco 8800 Series Hardware Installation Manual
Hide thumbs
Also See for 8800 Series:
- Manual (544 pages) ,
- Administration manual (406 pages) ,
- User manual (218 pages)
Table of Contents
Advertisement
Attach the Optical Network Cable
Step 7
Holding the pull-tab, fully seat the transceiver in the module's transceiver socket until it clicks.
Attach the Optical Network Cable
Before you begin
Before you remove the dust plugs and make any optical connections, follow these guidelines:
• Keep the protective dust plugs installed in the unplugged fiber-optic cable connectors and in the transceiver
• Inspect and clean the MPO connector end faces just before you make any connections.
• Grasp the MPO connector only by the housing to plug or unplug a fiber-optic cable.
Note
The transceiver modules and fiber connectors are keyed to prevent incorrect insertion.
Note
The multiple-fiber push-on (MPO) connectors on the optical transceivers support network interface cables
with either physical contact (PC) or ultra-physical contact (UPC) flat polished face types. The MPO connectors
on the optical transceivers do not support network interface cables with an angle-polished contact (APC) face
type.
Note
Inspect the MPO connector for the correct cable type, cleanliness, and any damage. For complete information
on inspecting and cleaning fiber-optic connections, see the
Connections
Procedure
Step 1
Remove the dust plugs from the optical network interface cable MPO connectors and from the transceiver
module optical bores. Save the dust plugs for future use.
Step 2
Attach the network interface cable MPO connectors immediately to the transceiver module (see figure below).
Hardware Installation Guide for Cisco 8800 Series Routers
64
optical bores until you are ready to make a connection.
document.
Connect Router to the Network
Inspection and Cleaning Procedures for Fiber-Optic
- Quick Links:
- Connect the Power Modules
Hide quick links:
Advertisement
Table of Contents
