Table of Contents
Advertisement
Dump Progress Indicators
The following dump progress indicators, or dump status codes, are part of a Type 102
message.
Note: When a lowercase c is listed, it displays in the lower half of the seven-segment
character position. The leftmost position is blank on the following codes.
0c0
0c2
0c3
0c4
0c5
0c6
0c7
0c8
0c9
Type 103 and 105 Messages
Message types 103 and 105 contain service information. The information should be
recorded on the "Problem Summary Form" or on a blank sheet of paper.
This message contains the SRN and the location codes for up to four FRUs. The SRN is
reported to the service organization and the location codes are needed by the service
representative. See "Reading Flashing 888 Numbers" on page B-13 for information about
the diagnostic information contained within this message.
B-14
Operator Guide
The dump completed successfully.
A dump, requested by the user, is started.
The dump is inhibited.
The dump did not complete. A partial dump may be present.
The dump program could not access the dump device.
A dump to the secondary dump device was requested. Make the secondary
dump device ready; then press Ctrl-Alt-Numpad2.
Reserved.
The dump function is disabled.
A dump is in progress.
Hide quick links:
Advertisement
Table of Contents
