D-Link DCS-3715 Quick Installation Manual
Full hd ip camera
Hide thumbs
Also See for DCS-3715:
- Selection manual (6 pages) ,
- User manual (78 pages) ,
- Quick installation manual (61 pages)
Related Manuals for D-Link DCS-3715
Summary of Contents for D-Link DCS-3715
- Page 1 Quick Installation Guide Full HD IP Camera This document will guide you through the basic installation process for your new D-Link Network Camera. DCS-3715 Documentation also available on CD and via the D-Link Website...
-
Page 2: Quick Install Guide
This installation guide provides basic instructions for installing the DCS-3715 IP Camera on your network. For additional information about how to use the camera, please see the User Manual which is available on the CD included in this package or from the D-Link support website. Installation Steps 1. -
Page 3: Hardware Overview
Press and hold this button for 10 seconds to reset the camera 1. MIC ON: Internal/External microphone on 2. MIC OFF: Internal/External microphone mute 3. NTSC: TV output signal selector 4. PAL: TV output signal selector D-Link DCS-3715 Quick Install Guide... -
Page 4: Front Panel
Lens Connector Connect to a CS mount Built-in MIC Internal microphone Right Panel DC-Iris Connector Lens ring Connector for DC auto Loosen the ring screw iris lens to adjust the back focus of lens D-Link DCS-3715 Quick Install Guide... -
Page 5: Hardware Installation
PoE will transmit both power and data over a single cable. Note: Once power has been established, the LED will turn red. When the device has obtained an IP address and is accessible, the LED will turn green. D-Link DCS-3715 Quick Install Guide... - Page 6 Hardware Installation 4. Configuration with Wizard Insert the DCS-3715 CD into your computer's CD-ROM drive to begin the installation. If the Autorun function on your computer is disabled, or if the D-Link Launcher fails to start automatically, click Start > Run. Type D:\autorun.exe, where D: represents the drive letter of your CD-ROM...
- Page 7 Next. Note: The installation may take several minutes to finish. Click Finish to complete the installation. Click on the D-Link Setup Wizard SE icon that was created in your Windows Start menu. Start > D-Link > Setup Wizard SE D-Link DCS-3715 Quick Install Guide...
- Page 8 Select static IP if the camera will use the same IP address each time it is started. Click Next, to proceed to the next page. Take a moment to confirm your settings and click Restart. D-Link DCS-3715 Quick Install Guide...
-
Page 9: Viewing Camera Via Web Browser
Configuration Viewing Camera via Web Browser Click on the D-Link Setup Wizard SE icon that was created in your Windows Start menu. Start > D-Link > Setup Wizard SE Select the camera and click the button labeled "Link" to access the web configuration. - Page 10 Adjust Zoom Ratio Unscrew zoom controller make adjustments. Adjust the zoom factor by moving the controller the left or right until the desired range is achieved. Tighten the zoom controller once completed. D-Link DCS-3715 Quick Install Guide...
- Page 11 D-ViewCam Installation Notes D-Link DCS-3715 Quick Install Guide...
-
Page 12: Technical Support
Copyright ©2011 D-Link Corporation/D-Link Systems, Inc. All rights reserved. D-Link and the D-Link logo are registered trademarks of D-Link Corporation or its subsidiaries in the United States and other countries. Other trademarks are the property of their respective owners. Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead lower actual data throughput rate.