Advertisement
Quick Links
12V Power Plug Adapter Kit
Workman
Model No. 07318—Serial No. 310000001 and Up
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
1
Preparing the Machine
No Parts Required
Procedure
CAUTION
Batteries can give you a powerful electrical shock.
• Use tools with plastic handles or wrap the
handles of metal tools with electrical tape.
• Be careful not to contact both a positive terminal
and a negative terminal at the same time.
1. Position the vehicle on a level surface, engage the
parking brake and rotate the On/Off key to the Off
position.
2. Raise the bed to access the vehicle batteries. Remove
one of the battery cables linking any two batteries
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
MDE Utility Vehicle
Description
No parts required
Converter mount
Converter
Flange bolt (1/4 x 3/4 inch)
Lock nut (1/4 inch)
Fuse assembly
Power plug assembly
Bolt (5/16 x 3/4 inch)
Lock nut (5/16 inch)
Wiring harness
Wire ties
Register at www.Toro.com.
Qty.
–
Prepare the machine.
1
1
Assemble the converter.
4
4
Install the fuse assembly and electric
1
mount plate.
1
Install the power plug assembly.
2
2
Mount the converter.
1
4
in the bank to remove power from the system
(Figure 1).
1. Battery link cable
3. Open the front hood to gain access to front end of
the machine.
Form No. 3363-440 Rev A
Installation Instructions
Use
Figure 1
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Advertisement
Related Manuals for Toro 07318
Summary of Contents for Toro 07318
- Page 1 Form No. 3363-440 Rev A 12V Power Plug Adapter Kit Workman ® MDE Utility Vehicle Model No. 07318—Serial No. 310000001 and Up Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty.
- Page 2 Assembling the Converter Installing the Fuse Assembly and Electric Mount Plate Parts needed for this procedure: Parts needed for this procedure: Converter mount Converter Fuse assembly Flange bolt (1/4 x 3/4 inch) Lock nut (1/4 inch) Procedure Install the fuse assembly to the open hole between the Procedure two existing fuses under the dash (Figure 3).
- Page 3 Installing the Power Plug Assembly Parts needed for this procedure: Power plug assembly Procedure Figure 6 1. Dash underside 3. Power plug outer casing 1. On the dashboard, from the operator’s position, 2. Power plug interior measure 2-7/8 inches to the right of the center of the key hole and 1-1/4 inch from the bottom edge of the switch cluster (Figure 4).
- Page 4 Mounting the Converter and Installing Wiring Harness Parts needed for this procedure: Bolt (5/16 x 3/4 inch) Lock nut (5/16 inch) Wiring harness Wire ties Procedure 1. Remove the Operator’s Manual tube from the dash. Loosen the fasteners securing the R-clamps and tube to the dash (Figure 7).
- Page 5 G005323 Figure 9 4. Plug, power plug 1. Underside of the dash 2. Main wiring harness 5. Plug, shown transparent for illustration purposes 3. Power plug assembly 6. Connect the two single red wires to the fuse installed in the solenoid plate. 7.
- Page 6 Notes:...
- Page 7 Notes:...