Toro TimeCutter ZS 4200S Operator's Manual page 47
Hide thumbs
Also See for TimeCutter ZS 4200S:
- Operator's manual (236 pages) ,
- Operator's manual (52 pages) ,
- Operator's manual (52 pages)
Table of Contents
Advertisement
Available languages
Available languages
8.
Install the washer and hairpin cotter
9.
Repeat steps
6
through
the machine.
10.
Check the side-to-side level again; repeat this
procedure until the measurements are correct.
11.
Continue leveling the mower deck by checking
the front-to-rear blade slope; refer to
the Front-to-Rear Blade Slope (page
Adjusting the Front-to-Rear Blade
Slope
1.
Rotate the adjustment nut in the front of the
mower
(Figure
68).
1. Adjusting rod
2. Adjusting block
2.
To raise the front of the mower, tighten the
adjustment nut.
Figure 67
(Figure
8
for the other side of
Checking
43).
Figure 68
3. Adjustment nut
3.
To lower the front of the mower, loosen the
adjustment nut.
4.
After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip; refer to
the Front-to-Rear Blade Slope (page
5.
When the front-to-rear blade slope is correct,
check the side-to-side level of the mower again;
refer to
Checking the Side-to-Side Level (page
43).
g294195
67).
g294471
45
Checking
43).
- Quick Links:
- Servicing the Engine Oil
Hide quick links:
Advertisement
Chapters
Table of Contents
