Page 1
304NCH FREE-STANDING ELECTRIC RANGE Model Serial Number Plate Automatic Oven Light Switch Removable Copy Model Your Serial Number Ehpool Model RJE-362B Here Control Panel One-Piece + Chrome Reflector Bowls...
Oven Signal Light Oven Temperature Cdntrol Table of Contents BEFORE USING YOUR RANGE USING THE SURFACE UNIT CONTROLS USING THE OVEN CONTROLS Baking... Broiling Variable Broil Feature Resetting the Oven Temperature Con&l SETTING THE CLOCK TO THE CORRECT USING THE MINUTE TIMER USING THE AUTOMATIC...
Page 3
Surface Unit Signal Light Surface Unit Control Knobs Before be sure you use your range as it was meant to be used. Before using it. you are personally responsible for making sure that it is properly installed and leveled on a floor that will hold the weight. and in a well-ventilated room is connected only to the right kind of outlet.
Page 4
Using them. This helps avoid turning them on accidentally when wiping off the Control Panel. And it helps keep small children from turning them on. You must push in on them. ..then turn to the setting (For example. [ . 1 shows that tile right front unit.. the one closest to you on your right..
Page 5
sitions for different kinds of meats when the Oven Selector Knob is set to BROIL. Food ALWAYS broil with door open about inches (10 cm). ; .I\‘t’r Variable Broil Feature: loosen the Locking Screw can be slowed down by setting a lower temperature on the Oven Temper- ature Control Knob Instead of “BROIL.”...
Page 6
Setting 1 Push in the Minute Timer Knob and turn it clockwise to set the hands to the correct time of day. 2. The Minute Timer hand will turn as you set the clock. When the clock is set, let the knob pop out. Then, while it is out. turn the Minute Timer hand clockwise to “OFF“...
Page 7
3. Push in and turn the Start Time Knob clockwise to the time you want the oven to start. 5. Turn the Oven Temperature Control Knob to the temper- ature you want to use to cook the food. When cooking is finished, turn both the Oven Selector and the Oven Temperature Control Knobs to “OFF”...
Page 8
Oven rack positions them to be before you turn on the oven. until It stops. Then lift stops, out of the guides and out of the oven. the oven and slide it in. keeping the front tilted up until the rack passes the stops in the rack guides.
Page 9
The oven vent There is an ol’en vent under the right rear surface element. When the ol’en is on. heated air will escape through it. A vent is needed for air circulation in the oven durtng baking. You can cook on this surface unit whtle the oven is on A warm pan of food will stay warm on this unit while the oven is on.
Page 10
Setting the controls to the Self-Cleaning CJeleclor 1. Set the Oven Selector Knob to “CLEAN.” 3. The clock and dials for start and stop time should all have the right time of day. 5. Lock the oven door by moving the Lock Lever all the way to the right.
Page 11
How the Self-Cleaning cycle works: When oven controls are set to “CLEAN.” than it does for cooking This high heat causes soil on the inside oven walls to burn oft or break up and mostly disappear While this is happening, a sptcial part in the oven vent helps remove smoke. not cover the rtgtlt-rear surface unit during the cleaning cycle The chart below shows about what happens during a 2-hour Self- Cleaning cycle Any time less than that shortens only the cleaning...
Page 12
Special tips: If the cleaning cycle doesn’t get the oven as clean as it should be. the time set for cleaning was probably not long enough. Set the cleaning time longer next time You can set it for more than 3 hours.
Page 13
Removing surface units and reflector bowls: I ,\ 1 First. be sure the Surface Unit Controls are all “OFF“ and that the Terminal surface units are (001. 2 Set) where the surface units plug into the range? Lift each surface unit about an inch (2 5 cm) at the edge away from the plug-In (receptacle).
PART WHAT TO USE Soft cloth. warm soapy water Outslde of appliance Nylon or plastic scouring pad for stubborn spots Surface units No cleaning required Control knobs Warm, sudsy water and bristle and chrome brush rims Chrome Automatic dishwasher or reflector bowls warm, soapy water or plastll- scrubbing pad...
Page 15
United States. tit-i!? is lust a phone call Whirlpool franchtsed TECH CARE” service representative Whirlpool malr!tai?s a nationwide TECH-CARE service companies to fulfill your warranty and provide after- warranty service anti m.r:ntcznance to keep your WHIRLPOOL in peak condition you follow these Instructions.)
Page 16
Also. retain your sales slip and war- ranty to venfy L’our ujarranty status. Remember.. Your TECH-CARE service representative is specially trained in the expert repairing and servicing of your WHIRLPOOL He can help you maintain WHIRLPOOL telephone number arid lot it down in the space provided on the cover.