Advertisement
Quick Links
Canopy Kit
Workman 1100/2100 and Twister
Model No. 07297
Model No. 07297R
Safety and Instruction Decals
Safety decals and instructions are easily
visible to the operator and are located near
any area of potential danger. Replace any
decal that is damaged or lost.
104-6731
Assembly
1. Position the machine on a level surface. Set the parking
brake, turn the ignition off, and remove the key.
Caution
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition switch before
you do any maintenance.
2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Utility Vehicle
Installation Instructions
2. If your vehicle has a Roll Over Protection System
(ROPS), proceed to step 3. If your vehicle does not
have a ROPS, proceed as follows:
A. Loosely attach the support brackets to the rear
support tube with 8 screws, 4 (5/16 x 2-3/4 in.) and
4 (5/16 x 1-3/4 in.); 16 flat washers (5/16 in.); and 8
flange nuts (5/16 in.) (Fig. 1).
B. Loosely attach the support brackets to the vehicle
with 8 screws (5/16 x 1 in.), 16 flat washers
(5/16 in.), and 8 flange nuts (5/16 in.) (Fig. 1).
3. Remove the rear bolt that holds the front fender to the
dash and front frame support on each side of the
vehicle. Do not remove the fenders from the vehicle
(Fig. 1).
8
Figure 1
1. Rear support tube
2. Left-hand support bracket
3. Screw, 5/16 x 2-3/4 in.,
and washer, 5/16 in.
4. Screw, 5/16 x 1-3/4 in.,
and washer, 5/16 in.
5. Flange nut and washer,
5/16 in.
1
Form No. 3326-769 Rev B
1
9
5
2
3
6
7
6. Screw, 5/16 x 1 in,. and
washer, 5/16 in.
7. Left-hand front fender
8. Right-hand front support
9. Left-hand front support
All Rights Reserved
Printed in the USA
4
Advertisement
Related Manuals for Toro 07297
Summary of Contents for Toro 07297
- Page 1 4. Screw, 5/16 x 1-3/4 in., 9. Left-hand front support and washer, 5/16 in. 5. Flange nut and washer, 5/16 in. 2001 by The Toro Company All Rights Reserved 8111 Lyndale Avenue South Printed in the USA Bloomington, MN 55420-1196...
- Page 2 4. Slide the slotted bracket on the front support between the fender and vehicle. Loosely attach the front supports to the floor of the vehicle using the existing hardware on the vehicle (Fig. 1). 5. Secure the fenders with the bolts removed in step 3. 6.