Leveling The Mower Side-To-Side; Adjusting The Right Side Front-To-Rear Mower Pitch - Toro GrandStand 74534 Service Manual
Hide thumbs
Also See for GrandStand 74534:
- Operator's manual (64 pages) ,
- Operator's manual (64 pages) ,
- Operator's manual (64 pages)
Table of Contents
Advertisement
Leveling the Mower Side-to-Side
1. Position the left blade front-to-rear (Fig. 719).
2. Measure the left blade at the A location, from a
level surface to the cutting edge of the blade tip and
record this measurement (Fig. 719).
3. Position the right blade front-to-rear (Fig. 719).
4. Measure the right blade at the C location, from a
level surface to the cutting edge of the blade tip and
record this measurement (Fig. 719).
5. The measurement between location A and C needs
to be within 1/8". If it is not correct, adjust the front
chain at location C to achieve the correct height.
Fig. 719
1. Measure here from the
blade to a hard surface
36" & 40" Toro GrandStand Service Manual
fig. 85 G012787
2. Measure at A & C
MOWER DECK
Adjusting the Right Side Front-to-Rear
Mower Pitch
1. Position the right blade front-to-rear (Fig. 720).
2. Measure the right blade at the C location, from a
level surface to the cutting edge of the blade tip and
record this measurement (Fig. 720).
3. Measure the right blade at the D location, from a
level surface to the cutting edge of the blade tip and
record this measurement (Fig. 720).
4. The mower blade should be a 1/4" to 3/8" (6 to
10mm) lower at position C than at position D (Fig.
720). If it is not correct, proceed to the following
steps.
5. The length of the threaded rod on the right side will
need to be adjusted to achieve proper front-to-rear
pitch.
6. Use the jam nuts at the front swivel to adjust the
length between front and rear swivels on that side.
7. Check to make sure there is equal tension on all four
chains. To get equal tension on all four chains, make
minor adjustments to maintain proper deck pitch.
Fig. 720
1. Measure here from the
blade to a hard surface
fig. 86 G012788
2. Measure at C & D
7-51
7
- Quick Links:
- Schematics
Hide quick links:
Advertisement
Table of Contents
